Vector Power On Board VEC012POB User Manual

Summary of Power On Board VEC012POB

  • Page 1

    8 jump-start system 12 volt dc power supply vec012pob user’s manual & warranty information important safety information, save these instructions to reduce the risk of injury, user must read and understand this instructional manual. This manual contains important information regarding the operation a...

  • Page 2

    Inflator safety 1. Never attempt to disable or block the inflation and deflation ports while pump is operating. 2. Never cover unit at any time. 3. Never leave the pump unattended while in use. 4. Never allow sand, small rocks or other debris to be sucked into the inflation or deflation ports. 5. Ri...

  • Page 3

    1 table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 control and function guide . . . . . . . . ....

  • Page 4

    3 1. Turn off vehicle ignition and all accessories (radio, a/c, lights, connected cell phone chargers, etc.). Place vehicle in “park” and set the emergency brake. 2. Make sure the jump-starter power switch is turned to off. 3. Remove jumper clamps from clamp tabs. Connect the red clamp first, then t...

  • Page 5

    5 (approximately 15 minutes, depending on ambient temperatures), as it may overheat. In such event, inflator will automatically shut down and restart after a cooling down period of approximately 15 minutes. Inflating tires or products with valve stems 1. Place connector (chuck) on valve stem. 2. Ens...

  • Page 6

    7 fuse replacement (dc charging adapter) 1. Remove the plug from the accessory outlet. Remove the gold cap by turning counterclockwise and lifting off. 2. Remove the center pin and spring. Remove the fuse. 3. Replace the fuse with a same type and size fuse (8 amp). 4. Replace the center pin and spri...