1 owner’s manual & warranty information jump-start system, air compressor and power supply vec020c tm pro pro portable, cordless, rechargeable 12 volt dc this manual contains important information regarding safety, operation, maintenance and storage of this product. Before using, read and understand...
2 safety information warnings: warning statements identify conditions or practices that may result in personal injury or loss of life. 1) when working with lead acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2) always use protective eyewear when ...
3 contents 1. Introduction ................................................................................. 4,5 2. Using start-it compact pro™ as a jumpstart system .............. 5,6 2.1 easy, step-by-step jumpstarting instructions ...................................................... 6,7 3. Char...
4 1. Introduction congratulations on selecting the vector® start-it compact pro™ jumpstart system, air compressor and 12 volt dc power supply. This compact jumpstarter is unique in the amount of energy it can supply for it’s size. The internal battery is a vector-developed high density sealed lead a...
5 1. 12 volt dc accessory socket, with 20 amp overload protection 2. Safety on/off power switch (no key required) 3. Charge status push button 4. Led charging/battery status indicators 5. Heavy-duty #6awg welding quality jumper cables 6. Heavy-duty, 350 amp copper clamps 7. Exclusive, quick-release,...
6 cable clamp holsters cable clamp compressor on/off switch figure 2 –side view 7. Do not attempt to jumpstart a frozen battery. 8. Never submerge this unit in water. 9. Do not wear vinyl clothing when jumpstarting a vehicle-friction can cause dangerous static electricity sparks. Remove all jewelry ...
7 positive ground systems: note : in the rare event that the vehicle to be started has a positive grounded system (positive battery terminal is connected to chassis): replace step 4 and 5 above with steps, 4a and 4b and then proceed to steps 6 through 8 below. 4a. Connect negative (-) black clamp to...
8 3.1 110/120-volt ac charging important: • make sure all switches are turned off during recharging • charge unit for full 24 hours, prior to first use • recharge unit fully after each use • recharge unit every two months, when it has not been used caution: make sure compressor switch is off otherwi...
9 4. Operation as a 12 volt portable power supply note: make sure that the unit ‘s safety on/off switch is always in the off position when using the 12 volt dc accessory outlet. 1. Lift up the cover of the unit‘s 12 volt dc cigarette lighter-type accessory receptacle (see figure 1). 2. Insert the 12...
10 6.1 compressor use important: read instructions carefully to avoid possible injury or property damage. The compressor may be used by removing the air hose from it’s storage channel and if required, fitting an appropriate nozzle to the air hose. An on/off switch located on the side of the unit con...
11 7. Replacement parts for replacement parts (bulbs, batteries, fuses, etc.), contact vector customer service: (954) 584-4446 or toll-free (866) 584-5504. 7.1 bulb replacement tools needed - small phillips screwdriver. 1. Unscrew (counterclockwise) and remove two phillips screws. 2. Remove the lens...
12 vector 120 day/two year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector...
