Vector START-IT MAXX VW022APC Owner's Manual & Warranty

Manual is about: Jump-Start System 260 PSI AIR COMPRESSOR 12 VOLT DC POWER SUPPLY

Summary of START-IT MAXX VW022APC

  • Page 1

    Owner’s manual & warranty information start-it® maxx™ jump-start system 260 psi air compressor •12 volt dc power supply vw022apc this manual contains important information regarding safety, operation, maintenance and storage of this product. Before using, read and understand all cautions, warnings, ...

  • Page 2

    2 note: this unit is shipped in a partially charged state. Before first use, charge for 24 hours using ac method. Safety information warnings: (warning statements identify conditions or practices that may result in personal injury or loss of life) 1) when working with lead acid batteries, always mak...

  • Page 3

    3 important: although this unit is delivered in a partially charged state, you must fully charge it with the supplied 110/120 volt ac charger for a full 24 hours before using it for the first time. You cannot overcharge the unit using the ac charger method. Cautions: (caution statements advise again...

  • Page 4

    4 contents 1. Introduction ..........................................................................................5, 6 2. Using vectorwoods™ jumper as a jump-start system ....................7 2.1 easy, step-by-step jump-starting instructions ......................................8 3. Charging/re...

  • Page 5

    5 1. Introduction congratulations on selecting the vector® jump-starter, air compressor and 12 volt dc power supply. This compact jump-starter is unique in the amount of energy it can supply for its size. The internal battery is a high density sealed, lead-acid battery that stores and delivers energ...

  • Page 6

    6 figure 1a (front view) figure 1b (rear view) 1. Reverse connection indicator 2. Good connection indicator 3. 12 volt dc accessory socket with 20 amp overload protection 4. Battery level pushbutton 5. Led charging/battery level indicators 6. Heavy-duty welding quality jumper cables 7. Heavy-duty co...

  • Page 7

    7 2. Use as a jump-start system warnings: 1. Before using this system to jump-start any vehicle or boat, read and understand all instructions, safety tips, warnings, cautions and first aid information provided in this manual and on the product labeling. Additional important information may also be p...

  • Page 8

    8 2.1 easy, step-by-step jump-starting instructions this jump-starter is equipped with an automatic safety switch that only allows jump-start energy to flow when proper connections are made to battery and frame. The automatic switch works in conjunction with an audible reverse polarity alarm and a l...

  • Page 9

    9 • always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns • keep out of children’s reach • always store battery clamps in built-in holsters when not in use and never touch battery clamps together, this can cause dangerous sparks, pow...

  • Page 10

    10 3.2 12 volt dc charging 1. Insert one end of the dc/dc charging adapter into a 12 volt dc accessory receptacle on the vehicle or boat. 2. Insert the plug at the other end of this charging adapter into the 12 volt dc accessory socket receptacle on the front of the unit. 3. Charge the unit until th...

  • Page 11

    11 5. Emergency worklight the worklight is controlled by an on/off switch. Make sure the lamp is turned off when the unit is being recharged or stored. The lamp is efficient and will operate up to 114 hours on a full charge. The ccfl lamp’s operating life is 100,000 hours. 6. Air compressor/tire inf...

  • Page 12

    12 6.2 tire inflation or products with a valve stem 1. Place connector (chuck) on valve stem. 2. Push connector toward valve stem and close thumb latch. 3. Make sure connector is pushed onto valve stem as far as possible before closing thumb latch. 4. Check pressure with the pressure gauge. 5. When ...

  • Page 13

    13 7. Replacement parts for replacement parts (bulbs, batteries, fuses, etc.), contact vector customer service: (954) 584-4446 or toll-free (866) 584-5504. 7.1 ccfl : ccfl lamp is designed for 100,000 hours of operation. It is not user replaceable. 7.2 battery replacement : it is recommended that th...

  • Page 14

    14 two year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector manufacturing,...

  • Page 15

    15.

  • Page 16

    © 2004 vector manufacturing, ltd. Ft. Lauderdale, fl 33312 made in china rd072604.