Vector START-IT VEC078 Owner's Manual & Warranty

Manual is about: AUTOMATIC BATTERY CHARGER

Summary of START-IT VEC078

  • Page 1

    Start-it ™ automatic battery charger owner’s manual & warranty information 12 volt 2/12 ampere with 100 / ampere start assist and manual 6 volt 15 ampere battery charge 1. Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For...

  • Page 3

    Vector “gold seal” 2/4 year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vecto...

  • Page 4: Appendix A - Charging Times

    Appendix a - charging times to calculate the approximate charging time required to fully charge a battery, it is necessary to determine the specific gravity (or, percent of battery charge) using a hydrometer. Use this technique, if battery vent caps can be removed. Check each cell. If there is one c...

  • Page 5

    Personal precautions and safety 1. Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery. 2. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 3. Wear complete eye protection and clothin...

  • Page 6: Preparing to Charge

    Preparing to charge 1. Determine voltage of battery by referring to car owner’s manual and make sure that output voltage selector switch is set at correct voltage. 2. If it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove grounded terminal from battery firs...

  • Page 7: Troubleshooting

    Service. Follow these simple steps to maintain the charger in optimum condition: • after each use, clean the battery charger clamps - be sure to remove any battery fluid that will cause corrosion of the copper clamps. • clean the outside case of the charger with a soft cloth and, if necessary, mild ...

  • Page 8: Charging Times

    Sheet-metal body parts: connect only to a heavy gauge, stable metal part of the frame or engine block. Note: if there is any problem connecting the charger clamps to the battery terminals, contact the vector technical support department at (954) 584-4446 or toll free at (866)-584-5504 for assistance...

  • Page 9: Introduction and Features

    H. See operating instructions for length of charge information. Introduction and features thank you for selecting the vector(r) model vec078 2/15/100 automatic battery charger. With proper care and use, it will give you years of dependable service. Please read all safety warnings and cautions, and t...

  • Page 10: Charger Controls

    Charger controls charger controls are located on the front panel. Understand control use before operating charger. Charge rate selector switch • the charge rate selector switch on the front panel of the charger (figure 3) offers two 12 volt and one 6 volt charge rates for charging various types of b...

  • Page 11: Circuit Breaker

    Higher, so it needs to rest after charging to measure actual state of charge. Below the ammmeter is an incorrect polarity indicator that lights when incorrect polarity is sensed. It is marked reverse. See figure 6a. It indicates that the charger to battery connection is reversed and it must be recon...