Summary of Start-IT VECO21 ST
Page 2
Table of contents warnings 1 cautions 2 features 3 important safety information 4 1. Introduction 5 2. Using start-it tm as a jumpstart system 2.1 easy, step-by-step jumpstarting instructions 6 3. Charging/recharging 3.1 110/1 20-volt ac charging 8 3.2 12-volt dc charging 8 3.3 110/120-volt ac charg...
Page 3
Warnings warning statements identify conditions or practices that may result in personal injury or loss of life 1. When working with lead acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2. Always use protective eyewear when using this product: con...
Page 4
Cautions caution statements advise against certain conditions and practices that may result in damage to vehicles, appliances, and/or the start-it jumpstart system. Tm 1. Important: although this unit is delivered in a partially-charged state - you must fully charge it with the supplied 110/120-volt...
Page 5
Features ! ! Heavy duty, professional quality ! Easy-to-use: emergency jumpstarter for cars, light trucks, let skis, snowmobiles, farm equipment, airplanes, boats, small suvs and rvs (almost any 12-volt battery system) ! Provides instant 12-volt dc power — whenever, and wherever it * s needed ! Idea...
Page 6
Note: the start-it jumpstart system is equipped with an audible reverse polarity alarm. This feature is only active when the safety switch is turned off. After both battery clamp connections are made during jump-start procedures, if you hear a buzzing sound, do not turn on the safety switch. You mus...
Page 7
1. Introduction congratulations on selecting the vector® start-it jumpstart system & 12-volt dc power supply. Tm please read this guide carefully before use to ensure optimum performance and avoid damage to the unit or items that you are using it with. The vector® start-it jumpstart system & 12-volt...
Page 8
2. Using the start-it as a jumpstart system tm cautions: 1. Before using this system to jumpstart any vehicle or boat, read and understand all instructions, safety tips, warnings, cautions and first aid information provided in this manual and on the product labeling. Additional important information...
Page 9
Positive ground systems note: in the rare event that the vehicle to be started has a positive grounded system (positive battery terminal is connected to chassis): replace step 3 above with the following steps, and then proceed to steps 4-6 below. 3a. Connect negative (-) black clamp to vehicle batte...
Page 10
First aid: ! ! Skin: if battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention. ! Eyes: if battery acid comes in contact with eyes, flush eyes immediately— for minimum o...
Page 11
Average number of uses potential total number (jumpstart or discharges) of jumpstart or discharge cycles between recharges (lifetime of unit battery 1 1000+ 5 700+ 10 500+ 3. Insert the plug at the other end of this power cord into the 12-volt dc receptacle on the front panel of the unit. 4. Charge ...
Page 12
Estimated power estimated usage appliance type consumption (in watts) time (in hours) cell phone 1 120 hrs. Talk time fluorescent light 4 30 radio, fan, depth finder 9 21 camcorder, vcr, spotlight 15 12 power tools, bilge pump 24 7 electric cooler 48 4 air compressor, car vacuum 80 1.5 4. Operation ...
Page 13
5. Emergency/work light bulb replacement you will need a small phillips screwdriver 1. Replacement bulbs are available from vector® customer service department; call (954) 584-4446 ext. 19 or toll-free (866) 584- 5504 2. Remove two phillips screws from the lens. 3. Lift off the lens assembly. 4. Rem...
Page 14
Vector 120 day/two year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector ma...