1. DL manuals
  2. Vector
  3. Air Compressor
  4. VEC022DSCC
  5. Owner's manual and warranty information

Vector VEC022DSCC Owner's manual and warranty information

Manual is about: 260 PSI AIR COMPRESSOR and 12 VOLT DC POWER SUPPLY

Summary of VEC022DSCC

  • Page 1

    1 jump-start system 260 psi air compressor and 12 volt dc power supply vec022dscc if you should experience a problem with your purchase call toll free (866) 584-5556. In most cases a service representative can resolve your problem over the phone . Owner’s manual and warranty information key informat...

  • Page 2

    2 contents 1. Introduction ..........................................................................................5 2. Front panel ............................................................................................7 3. Vector jump-start system ...............................................

  • Page 3

    3 safety information warning: warning statements identify conditions or practices that may result in personal injury or loss of life 1. When working with lead acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2. Always use protective eyewear when us...

  • Page 4

    4 caution: caution statements advise against certain conditions and practices that may result in damage to vehicles, appliances and/or the jump- starter. Important: although this unit is delivered in a partially charged state, you must fully charge it with the supplied 110/120 volt ac charger for a ...

  • Page 5: 1.  Introduction

    5 1. Introduction congratulations on selecting the vector® jump-start system. This compact jump-starter is unique in the amount of energy it can supply for its size. The internal battery is a high density sealed, lead-acid battery that stores and delivers energy comparable to full sized ordinary jum...

  • Page 6

    6 8 9 10 18 16 15 14 12 7 1 1 6 5 4 2 17 19 3 11 13 1. 12 volt dc outlet 2. Ac recharge adapter barrel connector receptacle 3. Built-in area light 4. Negative (-) black clamp 5. 260 psi compressor air hose tire chuck 6. Positive (+) red clamp 7. Inflator push button 8. Fault led indicator 9. Alarm l...

  • Page 7: 2.  Front Panel

    7 2. Front panel indicators each indicator has a distinctive meaning. For instance the; fault led indicates the clamp/cable connection is reversed. Reverse cables will appear on the lcd display. Once the clamps/cables are connected correctly, ready to start will appear on the lcd display. Alarm soun...

  • Page 8: 3. Jump-Start System

    8 caution: use only adapters supplied with this unit. Never insert any other adapters into the charging or power receptacles on this unit. 3. Jump-start system warning: 1. Before using this system to jump-start any vehicle or boat, read and understand all instructions, safety tips, warnings, caution...

  • Page 9

    9 6. This vector® jump-starter is equipped with an internal, automatic safety switch. This switch only activates when connections to the battery are correctly made positive (+) to positive (+) and negative (-) to negative (-). An incorrect connection will sound an audible alarm indicating an incorre...

  • Page 10: Charging/recharging

    10 caution: • if engine fails to start, leave ignition key turned off and disconnect the negative (-) clamp first, then the positive (+) clamp. Try again later – the engine may be flooded. • recharge jump-start system after each use. Warning: • always disconnect the engine or frame jumper clamp firs...

  • Page 11: 4.2 12 Volt Dc Charging

    11 note: the unit cannot be overcharged using the ac method. The vector® jump-start system also comes with a dc/dc charging adapter for recharging the unit from a 12 volt dc accessory socket in a vehicle or boat. Dc recharging method will not recharge the unit as effectively as recharging from a 110...

  • Page 12: 6. Area Light

    12 5. Operation as a 12 volt portable power supply 1. Lift up the cover of the unit’s 12 volt dc accessory receptacle (see figure 1). 2. Insert the 12 volt dc plug from the appliance into the receptacle on the unit. 3. Switch on the appliance, and operate as usual. Caution: do not use this unit to o...

  • Page 13: 7.4 Typical Inflation Times

    13 7.2 tire inflation or products with a valve stem 1. Place connector (chuck) on valve stem. 2. Push connector toward valve stem and close thumb latch. 3. Make sure connector is pushed onto valve stem as far as possible before closing thumb latch. 4. Press unit’s on/off button (11) to activate the ...

  • Page 14

    14 table iii inflatables type pressure approximate time car tire 185/70r14 30 psi 5 min mid size suv 235/70r16 30 psi 14 min large size suv* 265/70r17 42 psi 20 min bicycle tire 26 x 1.25 95 psi 1 min basketball 5 “ 10 psi 30 seconds air mattress** twin 30 psi 30 min * inflating time may vary due to...