1. DL manuals
  2. Vector
  3. Work Light
  4. VEC146
  5. Owner's Manual & Warranty

Vector VEC146 Owner's Manual & Warranty

Summary of VEC146

  • Page 1

    This manual contains important information regarding safety, operation, maintenance and storage of this product. Read care- fully before use, and retain for future reference. 4140 s.W. 28th way, ft. Lauderdale, fl 33312 tel: (954) 584-4446 fax: (954) 584-5556 toll free: (866) 584-5504 www.Vectormfg....

  • Page 2: Important Safety Information

    Important safety information read and comply before use 1. Do not use or charge in rain or damp conditions. 2. Keep away from children - this is not a toy. 3. Bulb gets very hot. Do not touch while operating. Allow 5 minutes for cooling before changing the bulb. 4. Do not place combustibles near bar...

  • Page 3: Operation

    Operation a two-position on/off toggle switch controls the operation of the lantern. The lantern can be continuously lit for up to 1-1/2 hours on a full battery charge. Never operate the lantern during charging. Figure 1, shows the lantern lens (1), the lantern bezel (2), the position release pushbu...

  • Page 4: Dc Charging

    3 always recycle pr ba prba dc charging do not operate lantern while charging. Make sure that the dc charger is powered from the correct dc source. Use only the dc charger cord supplied with this unit. Use of any other may damage the lantern's internal charging circuits and void the warranty. To rec...

  • Page 5: Specifications

    4 specifications power module 110 vac to 7.2 vdc 1650 ma. Ul listed class 2 power supply. Battery . . . . . . . . . . . . . . . . . . . .Proprietary 6 volt, 4 amp hour, sealed, lead- acid. Ac adapter . . . . . . . . . . . . . . . . .12 volt, 300 ma, built-in. Ac adapter charging time . . . . . .26 -...

  • Page 6: Bulb Replacement

    Figure 2 bulb assembly bulb replacement if you suspect the bulb is burned out: a phillips screwdriver is the only tool required to replace the bulb; (replacement bulb h3 6 volt 15-watt halogen quartz is required). The replacement procedure is as follows: 1. Make sure the lantern switch is in the off...

  • Page 7: Cleaning

    Cleaning over time, there may be dust or fingerprints on the lantern. If necessary clean the lantern with, a soft clean oil-free cloth moistened with household window cleaner. Do not use alcohol based cleaners on plastic surfaces. This will eventually cause surface clouding. If the inside of the ref...

  • Page 8

    2 year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector manufacturing, ltd....