Vector VEC270S Owner's Manual

Summary of VEC270S

  • Page 1

    Vec270s this manual contains important information regarding safety, operation, maintenance and storage of this product. Read carefully before use, and retain for future reference. 4140 s.W. 28th way, ft. Lauderdale, fl 33312 toll free: (866) 584-5504 www.Vectormfg.Com 1 if you should experience a p...

  • Page 2

    3 2 1. Safety information and instructions 1.1 safety symbols the following symbols will be used throughout this manual. The following safety precautions must be followed at all times along with any additional existing safety rules. 1.2 charging instructions for best results, charge the battery in t...

  • Page 3

    5 4 20. There is a risk of explosive gases being released when lead acid batteries are being charged or discharged. Failure to follow instructions may cause property damage, explosive hazard, and/or personal injury. 21. Do not over inflate tires/inflatable items. 22. Although this unit contains a se...

  • Page 4

    7 6 3. Operation 3.1 120 volt ac recharging important: the unit must be off when the unit is charging or not in use. To recharge the battery using the 120 volt ac adapter (12), follow these procedures: 1. Push the compressor power switch and lantern/spotlight power switch to the "off" position. 2. I...

  • Page 5

    9 8 2. Plug the charger into a 120 volt ac electrical outlet. 3. The red charging light will come on indicating the battery is recharging and will remain on until charger is removed. No other indicator lights will come on. 4. Charge the unit for 18 to 22 continuous hours before initial use. After mu...

  • Page 6

    11 10 typical inflation times for products w/valve stems tire size pressure time from “0 155/80r 13" 26 psi 2.5 - 8 min. 185/70r 14" 30 psi 4.5 - 10 min. 235/75r 15" 30 psi 6.5 - 12 min. 235/85r 16" 50 psi 16.00 min. Bicycle tires 27 x 1" racing 95 psi 2.30 min. 4.2 other inflatables without valve s...

  • Page 7

    13 12 7.1 spotlight bulb replacement tools needed – phillips screwdriver 1. Unscrew bottom center screw from clear plastic cover 2. Lift and remove clear plastic cover 3. Unscrew the three screws holding the spotlight reflector (there are two screws in the bottom and one on top). 4. Lift and remove ...

  • Page 8

    14 1 year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than described herein. This vector manufacturing, ltd. Pr...