Vector VEC280 User's Manual & Warranty Information

Summary of VEC280

  • Page 1

    8 3. If you suspect a bulb is blown, check the bulb filament. If filament is coiled and unbroken, the bulb is not blown. If filament is blown, replace bulb. 4. If you suspect the main fuse is blown, check it and, if necessary, replace with a new 20 amp spade fuse. Specifications spotlight: 12 volt h...

  • Page 2

    Important safety instructions warnings • contains non-spillable sealed lead acid batteries. They must be recycled or disposed of properly. • do not dispose of batteries in fire, as this may result in an explosion. • do not open battery or short circuit, this may cause the battery to leak or get hot ...

  • Page 3

    1 table of contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 main fuse . . . . . . . . . . . . . . . . . . ...

  • Page 4

    3 viewing battery charge status press the battery charge level pushbutton to display battery status. The battery charge level indicator leds will light. Leds (from left to right): • red led indicates a low battery charge • two red leds indicate a medium level or partially charged battery • two red a...

  • Page 5

    5 inflating products without a valve stem using the compressor inflation of other items requires use of one of the adapters (nozzles). 1. Insert appropriate adapter (e.G. Needle) into the connector (chuck) on the air compressor hose and close thumb latch. 2. Insert adapter (e.G. Needle) into item to...

  • Page 6

    7 battery replacement/disposal it is recommended that the unit be returned to customer service for battery replacement. Contact toll-free (866) 584-5504. This unit contains a maintenance-free, non-spillable, sealed lead-acid battery. This battery is fully recyclable and should be accepted at any loc...