Vector VECTORLITE VEC118S Owner's Manual - 3. Operation

Manual is about: CORDED, CORDLESS RECHARGEABLE SPOTLIGHT WITH BUILT-IN AREA LIGHT

Summary of VECTORLITE VEC118S

  • Page 1

    Vec118s this manual contains important information regarding safety, operation, maintenance and storage of this product. Before using, read and understand all cautions, warnings, instructions and product labels, plus your vehicle's battery manufacturer guidelines. Failure to do so could result in in...

  • Page 2: Warnings

    2 important safety instructions warnings : contains non-spillable, sealed, lead acid battery. Must be recycled or disposed of properly. Do not dispose of batteries in fire, as this may result in an explosion. Do not open battery or short circuit, as this may cause the bat- tery to leak or get hot, c...

  • Page 3: 1. Introduction

    3 1. Introduction congratulations on purchasing vectorlite tm model vec118s, an advanced design combination spotlight and long lasting, soft incandescent area light. It uses two powerful proven-technology rechargeable, non-spillable, sealed, lead acid batteries that allow for years of dependable use...

  • Page 4: 3. Operation

    3. Operation the trigger switch is squeezed to turn on the spotlight. This provides momentary operation. The trigger switch may be locked in the on position to provide continuous light without continuously squeezing the trigger switch. To lock the trigger switch on, move the trigger lock to the up p...

  • Page 5

    5 4. Charging the vectorlite using ac recharge adapter 1. Locate the recharge port on the side of the spotlight (see figure 1). 2. Connect the charger to an appropriate ac power source. 3. Plug the charger's barrel connecter into the recharge port located near the handle. Note that the red led light...

  • Page 6: 5. Periodic Maintenance

    5. Periodic maintenance all batteries lose charge over time, especially when they are warm. Ac recharge is recommended every two months, when not in frequent use. Use the ac recharger and charge for the recommended time. If the unit has dirt on it, gently clean the outer surfaces of the spotlight un...

  • Page 7

    10. Insert the replacement bulb into the reflector's flange. 11. Put back and secure the hairpin retaining wires. 12. Connect the white bulb power wire to the red power wire. 13. Tighten the retaining screw on the flange. 14. Place the reflector in position in the body of the spotlight. 15. Replace ...

  • Page 8: Replacing The Batteries

    8 replacing the batteries the rechargeable, sealed, lead acid batteries have a life of several years, if recharged promptly after each use. When the fully charged batteries only provide about 10 minutes or less of spotlight operation, they should be replaced with new batteries. To replace the batter...

  • Page 9: Safe Battery Disposal

    9 warnings: do not allow bare wires or connectors to con- tact each other dangerous sparking can occur - note which wires are on the battery terminals 6. Note position of battery. Note which wire is on which terminal. 7. Disconnect the wires from the battery and set the battery aside. 8. Connect the...

  • Page 10

    © 2002 vector manufacturing, ltd. Ft. Lauderdale, fl 33312 made in china two year limited warranty program this limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of vector manufacturing, ltd., regarding this product. There is no other w...