O w n e r ’ s m a n u a l on-line ® 1400
W e at vectra fitness appreciate your selecting our on-line ® 1400 for your fitness program, and invite your questions and comments. We're sure that you’ll be pleased with your new vectra fitness gym. This owner’s manual provides you with safety rules, assembly instructions and routine inspection an...
Vectra on-line ® 1400 cable diagram note: the pulleys on this diagram are numbered to make the installation of new cables as easy as possible. Simply start threading the cables through the pulleys beginning with the lowest number and working up. For example, if you are installing an entire set of ca...
Vectra on-line ® 1400 limited warranty v ectra fitness, inc. Warrants, to the original owner only, this vectra on-line 1400 to be free from defects in materials and workmanship for component specific periods as outlined below. Purchaser must retain bill of sale to establish warranty rights. This war...
4. Now assemble press station frame member (c) to press post (b) (3/8-16 x 1/2 hex screw, qty: 4). To do this, first route the cable exiting the side of the press post (b) into the frame tools required: wrenches: one each 7/16”, 1/2”, and two each 9/16” end wrenches hex keys: 7/32”, 5/16” phillips s...
6. In this step, you will install the press arm (e), along with the press adjustment plate (f) to the machine. (large 1/2” i.D. Washer, qty: 1, and 1/2-13 x 1 button head screws, qty: 2). Begin by placing the press adjustment plate onto the press arm such that the latch pin is in one of the notches ...
14. Now install the weight stack inside the stack column (i). Ensure that the guide rods are in place as mentioned in step 10 above: the bottom end of each one holding a rubber bumper instructions 18. Attach the two cushions to the bench (1/4-20 x 3/4 hex screws, qty: 12). Tighten pad mounting screw...
14. Now install the weight stack inside the stack column (i). Ensure that the guide rods are in place as mentioned in step 10 above: the bottom end of each one holding a rubber bumper and positioned over a locator tube. Load the weight plates (15 for a 160 lbs. Stack or 20 for a 210 lbs. Stack) one ...
