Vectra Fitness VX-DC Owner's Manual - page 4
Other manuals for VX-DC:
Owner's Manual
of
8
Pull cable up through column and out the top.
Slide in both guide rods with screws at
top and round black bumpers at the bottom.
Loosely install front
screws to floor frame.
3/8-16 x 1" flat head
screws (3)
Install longer 3/4" screw through
frames to back foot.
3/8-16 x .75" hex screws (2)
Install rear frame screws.
3/8-16 x .5" hex screws (6)
Tighten all frame screws.
Lower all twenty weight plates down the guide rods one at a time
(with black round bumpers at the bottom). Spread the guide rods
apart to control and slow the dropping weight plate speed.
Wait until the chin bars are installed to mount the top plate.
Cable