1. DL manuals
  2. Vectronics
  3. Tuner
  4. VC-300DLP
  5. Owner's Manual

Vectronics VC-300DLP Owner's Manual

Manual is about: Antenna tuner

Summary of VC-300DLP

  • Page 1

    Vc-300dlp antenna tuner owner's manual 1 vectronics vc-300dlp antenna tuner features the vectronics vc-300dlp antenna tuner optimizes the performance of your antenna and transmitter, receiver, or transceiver by providing adjustable impedance matching. The vc- 300dlp also measures the power and stand...

  • Page 2

    Vc-300dlp antenna tuner owner's manual 2 other frequency coverage .............. 1.8 - 30 mhz power..................................... 150 watts continuous; 300 watts pep, ssb dimensions............................ 3.5" (89mm) h x 10.2" (266mm) w x 9.4" (240mm) d. Weight .............................

  • Page 3

    Vc-300dlp antenna tuner owner's manual 3 coax 2 selects the coax 2 connector, bypassing the impedance matching circuit but providing normal meter readings. Tuned mode coax 1 selects the coax 1 connector through the impedance matching circuit. Coax 2 selects the coax 2 connector through the impedance...

  • Page 4

    Vc-300dlp antenna tuner owner's manual 4 3. Coax 2 coaxial connector for output to antenna two. 4. Bypass coaxial connector for third coax output. Bypasses tuner, but meter circuits remain active. 5. Ground post / wing-nut type ground connector. 6. Balance output two banana jack connectors for outpu...

  • Page 5

    Vc-300dlp antenna tuner owner's manual 5 5. Connect any antenna that does not require the use of a tuner to the bypass (4) connector using a coax cable. This allows you to select this antenna from the output selector switch. 6. To avoid possible damage to the vc-300dlp, set the transmitter, antenna,...

  • Page 6

    Vc-300dlp antenna tuner owner's manual 6 5. Set output selector switch to the proper selection on the tuned side of the switch. Selecting any of the direct positions by passes the tuning circuitry altogether. 6. Rotate the transmitter, antenna, and inductor controls for maximum noise or signal as he...

  • Page 7

    Vc-300dlp antenna tuner owner's manual 7 technical assistance if you have any problem with this unit first check the appropriate section of this manual. If the manual does not reference your problem or your problem is not solved by reading the manual you may call vectronics at 601-323-5800. You will...

  • Page 8

    Vc-300dlp antenna tuner owner's manual 8 meter calibration meter calibration procedure • connect transceiver to transmitter in connector. • connect external 50 Ω load to coax 2 connector. • set the output select switch to the coax 2 direct position. • set the range button to 300 w and the peak/avg b...

  • Page 9

    Vc-300dlp antenna tuner owner's manual 9 schematic diagram vc-300dlp.