Vega Q700 Owner's Manual - Quick Setup

Q700

2

Quick Setup

Some info about reading the detail section

found later in the manual (indexing this sec-

tion would be helpful!)

Quick Setup Procedure

1. Attach the two wire whip

antennas to the BNC

connectors on the back panel

of the MS-700 master station.

2. Install the power cord and plug

it into the AC source. Turn on

the MS-700 with the front

panel power switch.

3. Insert fresh batteries into the

BP-700 bodypacks and turn

them "on" via the power switch

on the main volume control.

The power indicator near this

control should illuminate briefly.

4. Plug a compatible headset into

each BP-700. 

5. Make certain that the

operating frequency ranges of

the MS-700 and BP-700 match.

If there is any question, look at

the frequency labels on the

bottom of the MS-700 and

inside the battery compartment

of the BP-700’s.

6. Verify that the frequency

ranges and specific frequencies

programmed into the MS-700

and BP-700’s are those

authorized for the location. If

you are not certain that the

currently-programmed

frequencies are correct, verify

each of them using the

procedure on page 7.

7. Move the BP-700 beltpacks at

least 6 feet (2 M) away from

the MS-700 and separate them

from each other by at least 10

inches (40 cm). Momentarily

depress the “A” pushbutton.

8. Observe the "RF" LED's on the

receiver section of the front

panel of the MS-700. The LED

corresponding to each active

BP-700 should be illuminated.

If not, recheck that the BP-700

is turned on and that the

frequencies are correct.

9. In turn, momentarily depress

the "B" and "C" pushbuttons

on each BP-700. The

corresponding receiver "mode"

LED's on the MS-700 should

illuminate red for pushbutton

"B", green for "C" and orange

for “D”.

10. Depress the "on" pushbutton

on the front panel of the

MS-700 for each active receiver

channel. The adjacent LED

should illuminate to indicate

that the channel is selected. 

11. Speak into the headset

microphone for each BP-700

while alternately pressing and

releasing pushbutton "A" on

the unit. You should be able to

hear your voice in the headset

earpiece in one position or the

other. If not, the headset

microphone type may be set

incorrectly. See page 8 for

programming a BP-700 for

dynamic or electret

microphones.

Note

: Whether audio is present

when the pushbutton is

pressed or when it is released

depends upon the programmed

operating mode of the BP-700.

See page 8 for details.