VehiclePath AT312TT Installation Manual

Standard Installation

GPS Fleet Tracking

INSTALLATION GUIDE

Getting Started

Kit Contents:

•  Tracking device (with internal antenna & attached wiring harness)

Tools Required for Installation:

•  #10 x 3/4” self-tapping screws (exterior installs only)

•  Power drill

•  Voltmeter or test light

•  Wire stripper/cutter/crimper

•  Terminal/connectors

Connect RED Wire/POWER and Connect BLACK 

Wire/GROUND:

•  Locate a fused, constant 12 VDC power source and a suitable

 chassis ground.

•  Connect RED wire on harness to POWER source.

•  Connect BLACK wire on harness to chassis GROUND.

Connect WHITE Ignition Sense Wire:

The ignition sense wire enables tracking of ignition ON and OFF events.

To install, locate the vehicle ignition wire by consulting the appropriate

wiring  diagrams.  Connect  WHITE  ignition  sense  wire  to  the  vehicle’s

ignition source.

BEWARE! Do NOT source to a 12V accessory wire – 

        you must connect to the ignition wire in the FUSE BOX.

The  vehicle  ignition  wire  can  be  verified  by  measuring  the  vehicle’s

operating voltage while the engine is running. The vehicle’s ignition wire

should  read  0VDC  when  the  key  is  in  the  OFF  position  and  typically

between 11V and 14V when the engine is running

©2012 Spireon, Inc. l 2012-FLVP-IG1002

WIRING DESCRIPTION:

RED

12/24 VDC Constant Power

BLACK

Chassis Ground

WHITE

Ignition (biased low)

BLUE

Input 1 (biased high)

YELLOW

Not Used

BROWN

Not Used

GREEN

Not Used

ORANGE

Not Used