Veito CH2500 RW User Manual - page 8
50 cm
50 cm
1.8 m
1.8 m
•Always leave a clear space of at
least 0.5m from the left and right
of the unit. The unit must also have
at least 1.8m clear space above it.
Never put any obstacles nearer than
1.8m to the front of the heater.
The unit must be installed at least
1.8m height from the floor.
•Use the unit in places with easy eccess
to power sockets and that are well
ventilated.
•Never use connecting terminals in the
power lead. Always directly connect the
unit to the power.
PRECAUTIONS
7
Precautions for installation and before use
PRECAUTIONS FOR INSTALL
•Install the two L connection
parts to the back side of the
heater with the screws
supplied by keeping a
suitable distance between
them.
•Install the other two L
connection parts to the wall
with the screws and wall plugs
supplied by keeping the
same distance between them.
*After reading this, be sure to keep it at a place where
other users can refer to it at any time.
Place and secure the heater to
the wall with the L connection
parts by using the special
screws supplied.
Decide the best position for the
heater and fully tighten the
screws.
!
!
!
Never install the heater on a combustible
surface. ( wood, carton etc.)
Install the product at places that are visible to people.
(frequently observe the product for safety)
Install the product at places where users
always reside and be sure to equip fire
extinguisher.
Do not install at
places with high
temperature.
HOW TO INSTALL
*Keep packaking parts because they are necessary in
maintaining the heater for a long time.
•
The heater can be used as both horizontal and vertical. When the heater is plugged in,
it will automatically set its position.
•
Check there are no hidden cable before drilling holes for wall plugs.
•
Decide the position for the heater on the wall. Proceed as follows;