Veito FLOW Installation And Operating Instructions Manual - For Customers
Water flow
is too low.
The inlet water of
the device is
clogged.
Remove the filter
located on the device,
clean it and reinstall it.
Customer
Water does
not heat
sufficiently.
The thermal fuse
inside the unit has
blown.
Check the thermal fuse
in the device. Also check
the allowable inlet
temperature.
Technician
For Customers
Please read the safety warnings carefully.
Never expose the device to frost.
Customer Service
When you call the customer service, please inform our customer service
representative with serial numbers starting with
F75 or F90 on the label
located on the bottom of the device. These numbers can be found between
the two water connection records which are under the instant water heater.
Liquidation
This device has been marked accordingly with the European
regulation 2002/96/EG concerning waste electrical and electronic
equipment – WEEE. This regulation specifies the content of
EU-wide implementations concerning the buy-back and cycling
of old devices.
Please ask your authorized dealer for current liquidation methods.
Warranty
For this device, the warranty conditions issued by our representative office
in the country of purchase is valid. You can benefit from the warranty
conditions at all times provided from your authorized dealer or the country
representation. All rights of change are reserved.
EN