Vela Tango 100 Arthrodesis User Manual

Manual is about: Tango Series

Summary of Tango 100 Arthrodesis

  • Page 1

    Vela tango vela tango 100 vela tango 200 vela tango 200el vela tango 100el u s e r m a n u a l e n variant: manual no. 105017 vela tango 100 arthrodesis vela tango el sit-stand 100, 100el, 200 & 200el.

  • Page 2

    Table of contents 1.0. Introduction 3 1.1. Safety 4 1.1.1. Usage 4 1.1.2. Transport 4 1.2. Warranty 4 1.3. Unpacking the chair 5 1.4. Maintenance 5 1.4.1. Wheels 5 1.4.2. Frame 5 1.4.3. Upholstery 5 1.5. Recycling 5 1.6. User manual 6 1.6.1. Attaching the backrest 6 1.6.2. Adjustment of seat height ...

  • Page 3

    3 dear customer thank you for purchasing a vela tango. This user manual contains useful information about positioning, operating and maintenance of vela tango chairs. Important please read this user manual thoroughly and keep it for later use. This user manual must always accompany the chair. The us...

  • Page 4

    4 1.1. Safety this chair bears the ce mark and conforms to all applicable eu rules. The stool is manufactured by vela, vermund larsen a/s, goeteborgvej 8-12, 9200 aalborg sv, denmark. Vela tango el lives up to all emc-demands according to the iec 60601-1-2. Please exercise special caution when using...

  • Page 5

    5 1.3. Unpacking the chair vela tango is supplied in cardboard packaging, developed with conside- ration for the environment. If there are any parts missing or transport damage to the chair, plea- se contact your dealer immediately. Do not not try to repair any damage or use the chair. Content of th...

  • Page 6

    Vela tango vela tango el vela tango el 1. 3. 2. 6 1.6. User manual replacement of the gas spring may only be performed by the service support team from your dealer or a skilled technical person. 1.6.3. Changing place for height adjustment - right/left armrest or switch box (vela tango el) remove the...

  • Page 7

    7 1.6.7. Adjustment of back height adjust the back height by pulling up the lever situated at the bottom of the backrest. Remember to tighten the lever again afterwards. 1.6.8. Adjustment of armrest, height adjust by loosening the handwheel on the armrest bar and regulate the height of the armrest. ...

  • Page 8

    Vela tango el vela tango 8 1.6.12. Rotation (vela tango el) (optional) the seat is rotated by pushing down the lever situated on the front right side. Note: rotation is not standard on all configurations of vela tango el. 1.6.11. Rotation (vela tango) (optional) the seat is rotated by pulling up the...

  • Page 9

    Vela tango 200 vela tango el 9 1.6.15. Coxit split seat (optional) the angle of the coxit flaps can be set independently of each other so they can be adapted to the individual need of support. Loosen the hand screw under the seat, set the angle and tighten the screw. 1.6.16. Footrest (optional) stab...

  • Page 10

    1 0 1.6.18. Push handle (optional) push handle for transporting a person in the chair. The push handle should be mounted on the back wheel towers. Note: the push handle is also available in a configuration that can be adjusted in height. Loosen the screw located in the middle of the rod. Adjust the ...

  • Page 11

    1 1 1.6.21. Remote control (optional) the remote control is operated via buttons on the front. A vela remote control can have one or more functions. See the icons on the remote control to see what functions the buttons operate. Note: insert plug in remote control to operate. 1.6.22. Electric tilt (o...

  • Page 12

    701.210-4 © v ermund larsen a/s vela :: gøteborgvej 8-12 :: 9200 aalborg sv :: denmark :: +45 96 34 76 00 :: mail@vela.Dk vela.Eu.