Summary of CS6MX
Page 1
Cs 6mx operating instructions.
Page 2: Identifying The Parts
2 1) on off/ sensitivity control 2) iron vol. Control 3) pinpoint switch 4) disc vol. Control 5) disc control 6) ground control 7) control box mounting clip 8) loudspeaker 9) battery compartment 10) 8 x aa battery holder 11) battery contacts 12) search-head socket 13) headphone socket 14) control bo...
Page 3: 6Mx
3 cs 6mx cs6mx overview the cs6mx is a high performance specialist metal detector operating on the ‘motion’ principle. This means that the search-head must be kept moving at a steady sweep speed to achieve optimum performance. The 6mx features multiple discrimination allowing the user to detect the ...
Page 4: Rapid Start
4 follow these simple steps to start using the cs6mx within minutes: 1) insert the lower stem into the upper stem (first press in the spring clip). 2) twist the locking device so that the stem is locked at the required length. 3) coil the search-head lead around the stem. 4) plug the search-head lea...
Page 5: 6Mx
1) on off/sensitivity control. Rotary control switches the detector on/off and adjusts the sensitivity. Ground containing mineralisation and some beach situations may cause instability or false signals requiring a reduction of the sensitivity level. 2) ground level control. Start off with this set t...
Page 6: Assembling The Cs6Mx
6 assembling the cs6mx the stem lock should be slackened to allow the lower stem to enter the upper stem section. The spring clip should be pressed in to allow the lower stem to slide into the upper stem. This spring clip will pop into any of the holes in the upper stem and firmly fix the two stems ...
Page 7: Belt Mounting
Belt mounting squeeze the control box retaining clips together using your thumbs as shown in the photograph. The control box will now slide towards you free of the control box mounting clip. The control box can be fitted to your belt using the clip provided. In belt mounted use, be sure to wind the ...
Page 8: Detecting With The Cs6Mx
8 on the majority of inland sites the ground control should be set to auto and the recommended sensitivity setting between 7-9 on the scale will give the best results. Some types of ground may give rise to false signals and the sensitivity level should be reduced to a point where operation of the de...
Page 9: Detecting With The Cs6Mx
Searching. When the detector gives a signal, move the search-head to the approximate area where the signal was heard, hold the switch in pinpoint and move the search-head carefully around. The strongest signal will occur directly below the centre of the search-head. Dig a neat hole by cutting around...
Page 10
Sensitivity, ground effect & discrimination you will be able to get more performance out of your detector if you understand the relationship between three aspects of detector operation - sensitivity, ground effect and discrimination. If you increase the power of a metal detector too much the ground ...
Page 11
Sensitivity, ground effect & discrimination 11 discrimination chart. Actual performance will depend on site and soil conditions as well as target size and orientation. Many users will enjoy the full three tone audio discrimination by setting the the iron volume control to 8, the disc control to 6 an...
Page 12: Warranty & Service
C.Scope international ltd kingsnorth technology park wotton road ashford kent tn23 6ln uk telephone: +44 (0)1233 629181 fax: +44 (0)1233 645897 email: info@cscope.Co.Uk web: www.Csmetaldetectors.Com c.Scope is an iso 9001 accredited quality manufacturer. This equipment conforms to the emc directive ...