- DL manuals
- Velleman
- Metal Detector
- CS990
- Operating Manual
Velleman CS990 Operating Manual
Summary of CS990
Page 1
Cs990 professional metal detector operating manual gebruikers handleiding manuel de l’utilisation.
Page 2: Introduction
Cs-990 gb 1 cs-990 operating instructions introduction these metal detectors are recognised as the finest detectors available. They are designed with lasting quality, high technology input, and above all, value for money in mind. The only way to realise this value and quality is to carefully study a...
Page 3: Discrimination (Rejection)
Cs-990 gb 2 inland mineralised sites : the g 1 mode is the mode in which "ground exclusion" is achieved on the majority of inland sites. Beach and non-mineralised inland sites : the g 2 mode enables the detector user to ground exclude on wet salt sand beaches by using the variable ground exclude con...
Page 4
Cs-990 gb 3 diagram 1 a on/off tune control b simdisc control c ground exclude control d level control e auto-tune button f meter g battery check button h battery compartment i upper stem j middle stem k lower stem l search head.
Page 5: Assembly
Cs-990 gb 4 battery compartment diagram 2 please note that the second battery compartment is on the other side of the control box. Assembly how to assemble your cs-990. Your cs-990 comes to you dismantled for ease of packing. To assemble it, follow these few easy steps : 1. Locate the stems in the s...
Page 6: Controls and What They Do
Cs-990 gb 5 3. Place the batteries and leads into the special recess, replace the battery cover and slide it firmly into place until you hear it click into position. 4. Repeat this operation on the other side of the control box where the second battery compartment is located. Battery life will be ex...
Page 7
Cs-990 gb 6 c. Ground exclude control this control enables the user to select a mode of operation best suited to the site to be worked on, for instance: g 1 is the mode to be used on mineralised inland sites and can be used in conjunction with any of the simdisc modes described above depending on th...
Page 8
Cs-990 gb 7 g. Battery check battery check button g is provided as a guide to the battery’s condition. To check the battery condition, switch on the detector by turning the on/off switch in a clockwise direction whilst simultaneously pressing the auto-tune button, once the detector is tuned, release...
Page 9: Operating Procedure
Cs-990 gb 8 operating procedure the fundamental principle of detector operation is that the detector must be tuned to the correct level. This is the level when the signals are balanced, and this is indicated by the detector being neither silent nor sounding off. In fact, the correct tuning level is ...
Page 10
Cs-990 gb 9 small pieces of silver paper are indicated by an increase in volume, however the frequency may not alter and the meter needle will remain in the centre or move just slightly to the left. Larger pieces of silver paper and other metallic objects will be indicated by a meter needle swing to...
Page 11: Use In The Field
Cs-990 gb 10 use in the field detection area these detectors employ a total response search head which means that the object can be detected across the full width of the search head. Diagram 3 detection range detection ranges will vary depending on the size of the object, the length of time an objec...
Page 12
Cs-990 gb 11 salt damage if you use your detector continually in a salty environment, particularly when the wind is blowing off the sea, salty air can penetrate the control box. Corrosion can occur in vital parts of the delicate electronic circuitry. It is therefore recommended that precautions such...
Page 13
Cs-990 gb 12 the detector drifts out of tune (a) temperature drift caused by the change in air temperature when a machine is moved from a house or a car into the open. (b) the greater the change in temperature the more the drift, and up to 30 minutes may be needed for the electronic circuitry to acc...