Total solder points: 63 difficulty level: beginner 1 2 3 ⌧ 4 5 advanced 8 channel rf transmitter illustrated assembly manual h8058ip-1 k8058 k8058 for use wit h velleman k8056 rela y card, 8 adresses a llow the us e of multip le receivers in one room..
Specifications: • 433mhz operation • led function/mode indication • power supply: 3 aaa batteries (not included). • dimensions: 150 x 58 x 20mm (5.9" x 2.3" x 0.8") features: works together with the k8056 relay card. 8 addresses allow the use of multiple receivers. 'all clear'- function. Toggle or m...
3 assembly hints 1. Assembly (skipping this can lead to troubles ! ) ok, so we have your attention. These hints will help you to make this project successful. Read them carefully. 1.1 make sure you have the right tools: • a good quality soldering iron (25-40w) with a small tip. • wipe it often on a ...
4 1.3 soldering hints : 1- mount the component against the pcb surface and carefully solder the leads 2- make sure the solder joints are cone-shaped and shiny 3- trim excess leads as close as possible to the solder joint remove them from the tape one at a time ! Assembly hints axial components are t...
5 ld1 : 3mm red first : mount this led like in the drawing (fig. 1.0). Solder one lead, check the position, if necessary cor- rect it by heating the sol- dering. Next : solder the second connection. Last : bend the led exactly like the drawing (fig. 2.0). Fig. 2.0 construction r1 : 47 (4 - 7 - 0 - b...
6 construction ic1 : vk8058 programmed pic16f630. 9. Ic. Watch the position of the notch! Solder a wire of 8cm (Ø 0,20mm)to the negative (-) connection of the pcb. The other end of the wire will be soldered to the negative battery contact later on. Now place the battery contacts into the housing on ...
7 first bend the battery lips over before closing the enclosure (fig. 5.0). Connect now the wire that you earlier have mount to the negative battery lip. Connect a wire between the positive battery lip and positive connection on the pcb. Construction negative battery lip positive battery affix the s...
8 close the enclosure with the supplied screws. 12. Assembly assembly ve lle m an ® do not fasten the screws too tight!.
9 13. Keyboard layout keyboard layout & use 1 3 5 7 2 4 6 8 shift when the batteries are inserted for the first time : channels 1..8 are configured as 'toggle' and are accessable by pressing button 1..8. The indicator led will briefly light when a button is pressed. Briefly pressing the shift button...
10 setup hold 'shift' until the led lights to enter the 'set-up' mode. Choose one of the following options by pressing the corresponding button : (1) ‘toggle’/’pulse’-selection. (2) display the current remote control address (3) change remote/relay card address (4) force remote/relay card address to...
11 15. Pcb layout. Pcb.
12 velleman kit nv legen heirweg 33 9890 gavere belgium europe info ?: http://www.Velleman.Be modifications and typographical errors reserved © velleman kit nv h8058ip - 2004 - ed1 5 4 1 0 3 2 9 3 1 5 0 3 0
