Velleman WCM2 User Manual - page 3
WCM2
VELLEMAN
3
WCM2 – QUARTZ CLOCK MECHANISM WITH ALARM
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Operation
Insert 1 AA-battery of 1.5V in the battery compartment. Respect the polarity indications.
Remove all dials before attaching the WCM2 to the clock with 2 screws or clicking it into place. Mount the two rotary
switches on the back of the device and put the alarm "ON/OFF"-switch in the "ON"-position.
Turn the rotary time-setting switch at the back (marked by two clock hands on the housing) clockwise and stop
turning immediately when you hear a click and the alarm is activated: this is the WCM2's "alarm point".
Assemble the yellow hand (alarm): place it directly at 12 o'clock. In doing so, the user should neither push the hand
with his fingers nor use the rotary alarm-setting switch at the back (indicated by the clock symbol on the housing) to
move the yellow alarm hand. Consequently, the user should do the same for the green hour hand, the green minute
hand and the red seconds hand. All four hands are now fixed at 12 o'clock.
It is now possible to test the accuracy of the alarm time. Use the rotary time-setting switch at the back to advance the
hands clockwise until the 12 o'clock position is reached again. The user should hear the click and the alarm should
be activated between "11:58" and "12:02". The alarm will automatically be deactivated after half an hour.
If necessary, the procedure outlined above should be repeated until the alarm is activated between "11:58" and
"12:02".
The alarm time has now been calibrated: the alarm will be activated max. 2 minutes before or after any arbitrarily
installed alarm time.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
WCM2 – KWARTSHORLOGE MET ALARMFUNCTIE
1. Inleiding
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt weggeworpen,
dit toestel schade kan toebrengen aan het milieu.
Gooi dit toestel (en eventuele batterijen) niet bij het gewone huishoudelijke afval; het moet bij een
gespecialiseerd bedrijf terechtkomen voor recyclage.
U moet dit toestel naar uw verdeler of naar een lokaal recyclagepunt brengen.
Respecteer de plaatselijke milieuwetgeving.
Hebt u vragen, contacteer dan de plaatselijke autoriteiten inzake verwijdering.