Veloce LS-1 Linestage Owner's Manual - page 4
4 |
P a g e
SAFETY INSTRUCTIONS
Read the following instructions and precautions carefully before using your Veloce LS-1
Linestage.
1. Always disconnect your entire system from the AC mains before installing any piece of
equipment or testing or cleaning any piece of equipment or any connection
2. This product is shipped with a three conductor 100-230V AC mains power cord. To
avoid electric shocks the LS-1 SmartSupply must always be grounded. If your electrical
outlets will not accept this type of plug an adapter may be needed. In this case, make
sure that this adapter conforms to all local safety regulations and includes a ground
prong (or wire). If you are not sure of the integrity of your home electrical service,
contact a licensed electrician for assistance.
3. AC extension cords are not recommended for use with this product. If an extension
cord must be used, ensure that it is an approved type and is sufficient for the load.
4. Never use flammable or combustible chemicals to clean this unit
5. Never operate this product with any covers removed. Unplug the unit prior to
removing any exterior covers.
6. Never pour, spill or in any way allow liquids of any kind to enter the unit.
7. Never insert any objects into the cooling slots at the rear of the unit or into any other
openings.
8. Never replace any fuse with a type or value other than those specified.
9. Never attempt to repair this product. If a problem occurs contact your deal or Veloce
Audio directly.
10. Never expose this product to extremely high or low temperatures.
11. Always keep electrical equipment out of the reach of children.