Veloce MMF-009 Instruction Manual - page 6
After Sales Support
Telephone (Aus): 1300 886 649
Telephone (Nz): 0800 836 761
6
1. Choose the appropriate whisk and set it inside the jug (see "Assembly",
page 8).
2. Pour milk into the jug, making sure not to exceed the maximum level marked
on the inside of the jug. (The lower MIN/MAX markings are for frothing milk,
the top marking is the maximum level for heating milk.)
3. Put the lid on top of the frother, making sure it is tightly closed.
4. (a)
FrothingandHeating/HeatingOnly
Press the frothing/heating button: both the blue and the red indicator
lights will come on at the same time. When the milk is frothed and/or
heated, the blue light will go off and the red light will flash for 30 seconds,
indicating the milk is ready.
(b)
FrothingOnly
Press and hold the frothing button for 1 - 2 seconds: the blue indicator
light will come on.
It will stay illuminated for approximately 65 seconds,
when it will go off and the red indicator light will flash for 30 seconds,
indicating frothing has finished.
NOTE: A flashing blue indicator light indicates that the machine is working
at an overload. Switch off the milk frother immediately and pour out
some milk. Then try again, making sure the milk inside the jug is
below the marked maximum level.
5. After frothing or heating, allow 2 minutes for the thermostat to reset before
reusing the frother. To shorten this time, rinse with water and wipe dry after
each use.
Instructions
Whisk
Function
Max. capacity
Time (sec.)
Frothing Only
115ml
65
Frothing and Heating
115ml
60-90
Heating Only
(a small amount of froth)
240ml
130-140