Velocity XL RG Owner's Manual - page 33
O
WNER
’
S
F
LIGHT
M
ANUAL
65
64
XL
12. Inspect gear wells for condition, cleanliness, condition
13. Inspect aileron bellcranks, cables, and rod ends for
condition; lubricate as needed
14. Inspect aileron torque tubes for condition
15. Inspect wing attach bolts for condition and security
16. Inspect wing for fuel leaks
F. Landing Gear Group
1. Inspect nose gear strut for condition; lubricate
2. Inspect nose wheel for cracks, cuts and condition
3. Inspect nose wheel caster for security
4. Place aircraft on jacks
5. Inspect main tires for wear, cuts and proper inflation
6. Clean, inspect and re-pack main wheel bearings
7. Inspect brake linings for condition and wear
8. Inspect brake rotor for pitting and wear
9. Inspect brake caliper for condition and leaks
10. Inspect main gear spring struts for condition and
security and rigging
11. Inspect landing gear fairings for condition
G. Landing Gear Retraction Check
1. Perform gear retraction
2. Check wheel clearance in gear wells
3. Check gear door fit
4. Check operation of gear position lights
5. Check operation of warning horn
6. Perform operational check of emergency gear extension
7. Inspect hydraulic lines for leaks and condition
8. Inspect gear actuators for proper travel, leaks and security
9. Extend landing gear and check safe indications
H. Operational Checks
1. Check fuel pump and selector
20. Inspect wet compass for calibration card and security
D. Fuselage and Canard Group
1. Inspect battery for security
2. Service battery with water
3. Inspect electronic components in nose gear well for
security and condition
4. Inspect hydraulic power pack for condition and security
5. Service hydraulic fluid as required
6. Inspect landing light and lens for operation
7. Inspect fuselage structure for cracks and condition
8 Inspect antennas, mounts for condition and security
9. Inspect canard for nicks, condition and security
10. Inspect elevator for condition and travel
11. Inspect and lubricate elevator hinges
12. Inspect elevator control cables and rod ends for freedom
13. Inspect elevator tab for condition and rigging
14. Inspect all wiring for condition and safety
15. Inspect ELT for operation and security
16. Check ELT battery for expiration date
E.Wing Group
1. Inspect wing upper and lower surfaces for cracks and
condition
2. Inspect wing leading edge fences for condition and security
3. Inspect fuel caps for condition and operation
4. Inspect fuel tanks for proper placards quantity/grade
5. Inspect winglets for cracks and condition
6. Inspect both rudders for condition, travel and security
7. Inspect rudder hinges and return springs, lubricate
8. Inspect rudder control horns for security
9. Check rudder operation
10. Inspect ailerons for condition, cracks and security
11. Inspect and lubricate aileron hinges