Velodyne vTrue User Manual And Warranty Information - page 4
How to connect
To connect your vTrue headphones, plug the straight 3.5 mm (1/8”) Y-cable connectors into the ports of their
respective ear cups.
Each connector has a
red
or
blue
marking on the body of the connector. Match the connectors with the
corresponding color under the left and right ear cups. The cable with the
red
marking is for the
right
audio
channel, while the cable with the
blue
marking is for the
left
audio channel.
Plug the right-angle 3.5 mm (1/8”) connector into the audio output port on your audio device.
6.35 mm (1/4”) adapter:
Use the included 6.35 mm (1/4”) adapter
if your audio equipment uses a 6.35 mm
(1/4”) output port. Use of this adapter with
the control module cable eliminates control
function.
Wearing vTrue headphones
Located above the inside of each ear cup are markings for right and left audio channels.
Wear the ear cup marked “Right” over your right ear and the one marked “Left” over your left ear. The control
module is located on the cable connecting to the left ear cup.
Always turn down the volume on your audio equipment before wearing vTrue headphones. Once the ear cups
are comfortably seated over your years, gradually increase the volume to a moderate sound level.
Cleaning
Ear cups should be cleaned regularly for sanitary reasons and to prolong the life of your ear cups.
With a lightly dampened cloth, paper towel or disinfectant wipe, thoroughly clean the ear cups.
Use a dry cloth to pat away any remaining moisture.
Do not get the speakers or electronics inside of your
headphones wet. Liquids and heavy moisture can cause
damage to the electronics inside your headphones. Such
accidental damages are not covered under warranty.
Adjusting the headband
The headband on the vTrue is adjustable to fit different head sizes.
Hold the headband and adjust by pulling on the right and left ear cups.
The right and left ear cups should be centered over the ears.
Page 2 of 5
vTrue user’s guide