Veltia VUK018 Operating Instructions And Parts Manual - page 4
Operation
No-touch operation
Shake excess water from hands.
Place hands under the outlet to start operation.
Rub hands lightly and rapidly.
Stops automatically after hands are removed.
Periodic cleaning of the unit is recommended to ensure optimum performance.
Cleaning and Maintenance
Disconnect the electrical supply.
Remove the two cover-mounting screws.
Remove the cover.
Clean all dust lint from the interior of the dryer.
Replace the cover. Do not over tighten the screws.
Wipe the cover with a damp cloth and mild
cleaning solution. Do not Soak. Never use
abrasives to clean the cover.
Recommended mounting heights
- from bottom edge of dryer above finished floor (AFF)
Men
Women
Children 4-7 years
Children 8-10 years
Children 11-13 years
Children 14-16 years
Handicaped
(38")
960 mm
(32")
812 mm
(34")
860 mm
(36")
910 mm
(38")
960 mm
(34")
860 mm
(40”)
1000 mm
Operating Instructions and Parts Manual
Hand Dryer
Surface-mounted high speed hand dryer
3
Warm aır speed adjustment
Use flat blade screwdriver small enough to fit through access hole {Ø4,8mm [Ø3/16"]} in bottom grille of
cover (item 1). The adjustment potentiometer (item 20) is visible through the slots of the grille. With
respect to axis of screwdriver viewed from handle end, gently turn adjustment potentiometer
shaft clock-wise [CW] to increase power to maximum (shaft will hard stop; DO NOT OVERTURN!). Turn
tool gently CCW to reduce power as required (shaft will hard stop; DO NOT OVERTURN!). Note that at
minimum power the unit may not start if low line Voltage condition exists.
Heater Switch
1.Cut off the power, loosen the screw of the cover
and remove the cover.
2.Adjust the heater switch on the PCB with a
flathead screwdriver.
2.1 Turn the switch to "ON": heater on
2.2. Turn the switch to "1": heater off
Heater Element Switch ON/ OFF
i
tem 1
i
20
tem