Vendor Development Group ALWALL-25 Owner's Manual - Operation

Manual is about: Electric Flat Panel Fireplace Heater

Page of 16

Download

Print this page

Bookmark us

OPERATION

Read and understand

this entire owner’s manual, including

all safety information

before

plugging in

using

this product. Failure to do so could result in

electric shock,

fire, serious injury, or death.

Power

Make sure the ON/OFF switch, located on the control panel, is in the OFF position. Plug the power

cord into a 110~120 Volt 15 Amp grounded outlet (see

IMPORTANT SAFETY INFORMATION

Pages 2 and 3

). Make sure the outlet is in good condition and that the plug is not loose.

NEVER

exceed the maximum amperage for the circuit.

DO NOT

plug other appliances into the same circuit.

Temperature Limiting Control

This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe

temperature (212

F / 100

C), the heater will automatically turn OFF. To reset:

1. Unplug the power cord from the outlet.

2. Turn the ON/OFF switch on the CONTROL PANEL to OFF.

3. Wait 5 minutes.

4. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,

use a vacuum to clean the vent areas.

5. With the POWER switch in the OFF position, plug the power cord back into the outlet.

6. If the problem continues, have your outlet and wiring inspected by a professional.

Methods of Operation

This electric fireplace can be operated by the CONTROL PANEL, located on the right side panel of

the fireplace (see figure below), or by the battery-powered REMOTE CONTROL. Before operating,

please review the

IMPORTANT SAFETY INFORMATION

Pages 2 and 3,

and heed all warnings.

Meijer.com

« ‹ Prev 7 8 9 10 11 12 13 Next › »

Summary of ALWALL-25

Page 1
Electric flat panel fireplace heater owners manual model numbers: ef38b and alwall-25 only use this heater as described in this manual. Any other use is not recommended by the manufacturer, and may cause fire , electric shock , or other personal injury . Warning! Read and understand this entire owne...
Page 2: Warning
2 important safety information! Warning always keep electric cords , home furnishings , drapes , clothing , papers , or other combustibles at least 3 feet (0.9m) away from the front of this heater , and away from the bottom, sides, and rear of this heater. Do not place the heater near a bed because ...
Page 3: Warning
3 warning risk of electric shock ! Do not open! No user-serviceable parts inside! Always disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. Always store this heater in a dry location. Never use the fireplace if it has b...
Page 4: Preparation
4 preparation this carton includes a glass panel! Always use extreme caution when handling glass. Failure to do so could result in personal injury or property damage . Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Check to make sure nothing is missing. D...
Page 5: Assembly Instructions
5 assembly instructions step 1. Remove the mounting bracket (c) from the rear of the firebox (a) by unscrewing the two m4x10 machine screws (1) along the bottom edge of the firebox. Step 2. Find a safe location. Minimum clearance on each side must be at least 8 inches (20cm); minimum clearance from ...
Page 6
6 step 3. Locate the wall studs using an electronic stud-finder. Studs are spaced 16” apart as measured from the center of each stud. The holes in the mounting bracket (c) will align with the wall studs. The end of each arm has a hole. There are also two holes on the center post. Avoid injury and da...
Page 7
7 step 5. Thread one st5x40 wood screw (3) through the bracket, into the pilot hole, and into the stud . Partially tighten. Make sure the bracket is level. Thread the remaining three st5x40 wood screws into the other three holes. Check the alignment and tighten each screw securely with the phillips ...
Page 8
8 step 7. Center the wall mount bracket (c) over the wall stud. Level the mounting bracket and mark the two center post holes with a pencil. Mark the four outer holes for the drywall anchors. Step 8. Drill pilot holes into the two center marks using a 1/16” wood drill bit. Make sure each pilot hole ...
Page 9: A B
9 always unplug this fireplace heater before assembly or cleaning, or before relocating. Failure to do so could result in electric shock , fire , or personal injury . Step 10. Fit the slots in the back of firebox (a) over the hooks on the wall mount bracket, and press the firebox against the wall mo...
Page 10: Operation
10 operation read and understand this entire owner’s manual, including all safety information , before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. Power make sure the on/off switch, located on the control panel, is in the off po...
Page 11: Notice
11 notice when the heater is first turned on, a slight odor may be present. This is normal and should not occur again unless the heater is not used for a long period of time. Control panel operation (each symbol means press button once) button function press and indication on/off the on/off switch m...
Page 12: Remote Control Operation
12 remote control operation (each symbol means press button once) button function press and indication on/off the control panel switch must be on to use the remote control. This button turns on the flame and enables all functions. 1. Beep. Flame effect – high intensity. All other functions are now e...
Page 13: Care And Maintenance
13 remote control battery information • this remote control uses one cr2032 lithium-ion 3 volt button cell battery (included). • instructions for battery installation are inside the remote control battery compartment. Never dispose of batteries in ﬁ re. Failure to observe this precaution may result ...
Page 14: Maintenance
14 maintenance risk of electric shock ! Do not open! No user-serviceable parts inside! Always turn the heater off and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury . E...
Page 15: Limited Warranty
15 limited warranty this warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be...
Page 16
16 thank you for purchasing this electric fireplace! If you need assistance with assembly, have questions about the use of this product, or have missing or defective parts, please e-mail us at customerservice@vendord.Com or, call us toll-free (m-f 8:30 am to 4:30 pm central standard time) at 1-866-5...