1. DL manuals
  2. Vendor
  3. Indoor Fireplace
  4. KAMN-23
  5. Owner's Manual

Vendor KAMN-23 Owner's Manual

Summary of KAMN-23

  • Page 1

    Electric fireplace owners manual model kamn-23 only use this heater as described in this manual. Any other use is not recommended by the manufacturer, and may cause fire, electric shock, or other personal injury. Warning! Read and understand this entire owner’s manual, including all safety informati...

  • Page 2: Warning

    2 important safety information! Warning  always keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the bottom, sides, and rear of this heater.  do not place the heater near a bed because ob...

  • Page 3: Warning

    3 warning  risk of electric shock! Do not open! No user-serviceable parts inside!  always disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace.  always store this heater in a dry location. Never use the fireplace if it ...

  • Page 4: Preparation

    4 preparation a complete electric fireplace heater should consist of two parts; the wooden mantle and the fireplace heater. Each is packed in a separate carton. Always use the fireplace heater with the wooden mantle. Remove all parts from the carton and place them on a clean, soft, and dry surface. ...

  • Page 5: Assembly

    5 assembly step 1. Insert the wood dowel (c) into the back edge of side panels (2l/2r). Press rear panels (3l/3r) and side panels together so dowels go into holes in rear panels. Thread bolts (a) through washers (b) and connectors on side panels and into holes in rear panels. Secure with phillips sc...

  • Page 6

    6 step 3. Insert wood dowel (c) into holes in each end of shelf (4). Press shelf and side panels together so dowels go into holes in side panels. Thread bolts (a) through washers (b) and connectors on shelf and into holes in side panels. Secure with phillips screwdriver. Do not over-tighten. Step 4....

  • Page 7: Notice

    7 step 5. Thread wood screws (d) through holes in cross panel (6) and into holes in back edge of mantel assembly. Secure with phillips screwdriver. Tighten all bolts and screws. Ant-tip safety kit installation 1. Attach one bracket (g) to the wall with the long screw (e). Secure with a phillips scre...

  • Page 8: Limited Warranty

    8 limited warranty this warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be ...