Summary of VGF60
Page 1
Venini.Com.Au user manual 2 year warranty vgf60 60cm gas cooktop.
Page 3: 1800 444 357
Dear customer, congratulations on purchasing your new product from home appliances. To register your parts and labour warranty, some conditions apply, please refer to your warranty card for more details and contact our customer care team on: 1800 444 357 our customer care centre is there to ensure y...
Page 4: Built-In Stainless Steel Gas
Built-in stainless steel gas cooktop installation and user manual content safety instructions-------------------------------------- 3 product description------------------------------------- 4 installation------------------------------------------------ 6 start using your appliance------------------...
Page 5
2 this manual explains the proper installation and use of your appliance, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. In case of failure, only the authorized technical service may repair this hob. Ot...
Page 6
3 safety instructions safety when installation ! Do not use or store flammable materials in the appliance storage drawer or near this appliance. ! Do not spray aerosols in the vicinity of this appliance while it is in operation. ! Where this appliance is installed in marine craft or caravans, it sha...
Page 7
4 product description no . Model burner* fsd pan supports knob position total gas consuption over view 1 ghs604a-g2ci 1w+2sr+1a with 2 types for option front lpg: 30.5mj/h ng: 29.5mj/h 2 ghs604b-g2ci 1r+2sr+1a with 2 types for option front lpg: 27.5mj/h ng: 26.0mj/h 3 gh614as-g2ci 1w+2sr+1a with 2 t...
Page 8
5 accessory name picture ( for reference only, physical unit maybe different) quantity user manual 1 sealing tape 1 roll additional labels you have additional rating label in accessory bag, suggest attach it onto a surface where it can be read e.G. Inside surface of adjacent cupboard 1 set installat...
Page 9
6 installation before installation: ! Before cutting into any bench tops, ensure the minimum clearances to walls, adjacent surfaces and overhead surfaces required by the relevant gas appliance installation code (see above) will comply. Dimensions are specified in millimeters (mm) overhead cupboards ...
Page 10
7 2. Place burner box apply the adhesive sealing tape to the underside lip of the burner box. Shown at g opposite. Place burner box into cutout hole and fit clamping brackets to clamp the hotplate to the bench. 3. Fit burners and trivet. Replace burners and ensure they are correctly repositioned ove...
Page 11
8 after having installed the hotplate, the gpo must always be in an accessible position. Wiring diagram 4. Gas connection install in accordance with relevant gas standards and/or codes of practice applicable. Connect the elbow fitting to the appliance gas manifold connection, and check that seals be...
Page 12
9 adjusting the burner minimum flame height: note: this adjustment can only be performed by the installer or an authorised service personnel. The minimum burner flame is factory adjusted for the gas type stated on the gas type label adjacent to the gas connection and should not require adjustment. A...
Page 13
10 description explanation zone indicators these show which zone is under control. Flame power flame power of the zones, is the lowest and is the highest. The hotplates are fitted with mains powered electronic spark ignitors, so must be connected to mains power supply (i.E. Nominal 220~240 v ac) to ...
Page 14
11 maintenance & troubleshooting cleaning and maintenance should be carried out with the appliance cold especially when cleaning the enameled parts. Avoid leaving alkaline or acid substances(lemon juice, vinegar etc.) on the surfaces. Stainless steel the stainless steel hob of the hotplate must be c...
Page 15
12 troubleshooting servicing of the hotplates must only be done by an authorised service representative (see back of this booklet) and the hotplate must not be modified. Power must be disconnected before any servicing or maintenance is conducted. Do not modify this appliance. It is recommended the h...
Page 16
Distributed by: home appliances pty. Ltd. 20 carlotta street, artarmon nsw 2064 tel: 02 9958 3111 fax: 02 9958 3555 email: info@hapl.Com.Au website: www.Hapl.Com.Au.