Venmar CONNAISSEUR 3000 SERIES Installation Instructions And User Manual

Manual is about: Hood

Summary of CONNAISSEUR 3000 SERIES

  • Page 1

    Connaisseur 3000 series intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: use and care information on pages 9 to 11. Installation instructions and user manual read and save these instructions hb0010 www.Venmar-ventilation.Com 03506 rev e venmar ventilation in...

  • Page 2: Warning

    - 2 - warning warning to reduce the risk of fire, electric shock or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servici...

  • Page 3: Connaisseur

    Hl0009 - 3 - cbs series backsplash (optional) cbf series baffle filter (optional) adapter and damper (supplied with hood) flow deviator (vertical exhaust only) (supplied with hood) standard 3 1/4” x 10” duct (not included) 13282 3 1/4” x 10” to 8” transition (not included) standard 8” duct (not incl...

  • Page 4: 1.  Install Ductwork

    - 4 - 1. Install ductwork plan where and how the ductwork will be installed. Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. If using 8” round ducts, use the transition. Use 2” duct tape to seal duct joints. 2. Measure installation dimensions for...

  • Page 5

    - 5 - 3. Prepare the installation make sure that the following items are included: -hood -filters -bag of parts including : (1) wire clamp, (8) 1/2’’ double thread screws, (2) wire connectors, (2) 1/2’’ standard screws. -adapter/damper assembly 3-1/4’’ x 10’’ -deviator parts sold separately: - halog...

  • Page 6: 6.  Install The Adapter

    6. Install the adapter using (2) 1/2’’ screws, secure the adapter to the top or back of the hood. Tape the adapter to the hood using duct tape to seal it. Hd0005 hd0006 - 6 - 5. Choose the opening and install the deviator remove the knockout for the chosen opening (horizontal or vertical) at the bac...

  • Page 7: 8.  Connect Wiring

    - 7 - 8. Connect wiring connect cable to wiring box using wire connectors. Connect black to black, white to white, and green wire under ground screw. Reinstall wiring cover. Do not forget to connect the ground. 9. Light bulbs this range hood uses halogen lamps. (120v, 50w, par 20) install the lights...

  • Page 8: 11.  Install Filters

    - 8 - 11. Install filters it is recommended to install side filters first and finish with center one(s). Install as follows: mesh filter installation 1. Insert upper end of filter into the hood (finger sized cup side). 2. Raise lower end toward the inside of hood. 3. Position lower end of filter int...

  • Page 9: Use and Care

    Caution - 9 - use and care front in the dual blower, both impellers are different: one rotates clockwise and the other one rotates counterclockwise. Each wheel and motor have an arrow and a number on them, you must match them correctly (see drawing below). Filters and impeller(s) the grease filters,...

  • Page 10: Operation

    - 10 - hood cleaning stainless steel cleaning: how to maintain its « bright look » do: - regularly wash surfaces with clean cloth or rag soaked with warm water and mild soap or liquid dishwashing detergent. - always clean in the direction of original polish lines. - always rinse well with clear wate...

  • Page 11

    - 11 - 1. Delay switch: when a speed is selected, press the delay switch to activate the delay function. The corresponding speed indicator light will start flashing to indicate this function is activated. The fan will continue to operate for 5 minutes and will stop automatically. To cancel the delay...

  • Page 12: Technical Specifications

    - 12 - technical specifications transformer 120 vac, 60 hz lights 30”, 36” 42”, 48” size par20 2 x 50w 3 x 50w halogen bulbs heat lamps 120v, ir 175w, par 38 infrared bulbs 2 x 175w or halogen lamps 120v, 90w, par 38 2 x 90w blower: single p5 dual p8 hood width 30”, 36” 36”, 42”, 48” power 218 w 400...

  • Page 13: Warranty

    - 13 - venmar ventilation inc. Warrants to the original consumer purchaser of its products, that such products will be free from defects in materials or workmanship with in-home service for a period of one (1) year, five (5) years on parts only except for the filters, which is one (1) year, and ten ...

  • Page 14: Wiring Diagrams

    - 14 - wiring diagrams he0009 he0010 connaisseur 30” and 36” single blower connaisseur 36”, 42” and 48” dual blowers halogen lamp (50w par20) halogen lamp (50w par20) control board m2s pc48492-3 logic k1 no k2 no k1 nc j1-3 j2-4 k2 nc autotransformer 120 vac line 120 vac neutral spsp rocker switch s...

  • Page 15: Service Parts

    1 5 4 2 3 10 14 11 1 8 15 13 6 4 2 5 9 7 17 8 12 8 3 1 8 16 1 3 8 1 8 18 - 15 - service parts 3000 series single blower key part qty # number description 30” 36” 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 02264 02772 02563 03597 02802 03580 02414 03521 03522 03523 05520 13230 13296 03689 04279 ...

  • Page 16: Service Parts

    Hl0037 1 4 6 3 5 10 14 1 8 15 13 6 17 4 2 5 9 7 7 17 8 8 11 12 8 3 1 8 16 16 1 3 8 1 8 18 key part qty # number description 36” 42” 48” 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 02264 02772 02563 03597 02802 03580 02414 03521 03522 03523 05520 13230 13296 03689 04279 04280 13217 13218 13219 02...