Venmar Jazz VJ70524SS Installation Instructions Manual

Other manuals for Jazz VJ70524SS: Installation Manual
Manual is about: Chimney range hoods

Summary of Jazz VJ70524SS

  • Page 1

    Vj603302ss chimney range hood installation instructions intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: use and care information on pages 8 and 9. Read and save these instructions venmar ventilation inc., 550 lemire blvd., drummondville qc j2c 7w9 1-800-567...

  • Page 2: Warning

    2 to reduce the risk of fire, electric shock or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit,...

  • Page 3: Warranty

    3 warranty venmar jazz range hood 1-year limited warranty venmar ventilation inc. Warrants to the original consumer purchaser of its products, that such products will be free from defects in materials or workmanship for a period of one (1) year from date of original purchase. This warranty includes ...

  • Page 4: 1. Install

    4 1. Install ductwork warning ! When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves. Plan where and how the ductwork will be installed. A straight, short duct run will allow the hood to perform most efficiently. Long duct runs, elbows and...

  • Page 5: 3. Prepare

    5 3. Prepare installation warning ! Electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. This range hood must be properly grounded. Turn off electrical power at service entrance before wiring. Note: before proceeding to the installation, check ...

  • Page 6: 7.  Remove Grease Filters

    6 5. Install hood mounting bracket 1. Construct wood wall framing that is flush with surface of wall studs. Ensure: a) the framing is centered over installation location and is sturdy enough to support the weight of the hood. B) the height of the framing will allow the mounting bracket to be secured...

  • Page 7: 8. Install

    7 8. Install hood warning ! Be careful when installing the decorative flue and hood, they may have sharp edges. Caution do not remove the protective plastic film covering the decorative flue (upper and lower) and the hood yet. 1. Install 6" round adapter/damper on top of the hood using 4 no. 8 x 7/1...

  • Page 8: 10. Light Bulbs

    8 9. Reinstall grease filters to reinstall the grease filters, align rear filter tabs with slots in the hood. Pull down the metal latch tab, push each filter into position and release. Make sure filters are securely engaged after installation. Hd0256 10. Light bulbs this range hood requires two ul a...

  • Page 9: 11. Operation (

    9 11. Operation ( cont ’ d ) 1. Time/delay (d ouble function push button ): - t ime s etting : this button is used to set time when lighting and blower are not in use. Time is displayed in 24 hour cycle. To set time, press the push button (1) for 3 seconds. The first two digits will flash. Use the b...

  • Page 10: 13. Replacement Parts

    10 13. Replacement parts hl0128 7 1 2 3 4 3 5 6 r eplacement p arts and r epairs in order to ensure your ventilation unit remains in good working condition, you must use venmar ventilation inc. Genuine replacement parts only. Venmar ventilation inc. Genuine replacement parts are specially designed f...