I nstallation g uide models vj60330ss & vj60430ss r ead and s ave these i nstructions 07248 rev.A chimney range hoods ! I ntended for domestic cooking only . ! Installer: leave this guide to the homeowner. Homeowner : operation and care information on pages 7-8..
! To reduce the risk of fire, electric shock, or injury to person(s) observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning uni...
-3- 1. Install ductwork decide where the ductwork will run between the hood and the outside. A straight, short duct run will allow the hood to perform most efficiently. Long duct runs, elbows and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may ...
-4- 3. Prepare the installation unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly (lower and upper flues) 1 - parts bag containing: 1 - lower flue mounting bracket 1 - hood mounting bracket 1 - upper flue mounting bracket 4 - decorative flue bracket screws (#8...
C l 5. Install hood mounting bracket 1. Construct wood wall framing that is flush with surface of wall studs. Make sure: a) the framing is centered over installation location. B) the height of the framing will allow the mounting bracket to be secured to the framing within the dimensions shown. 2. Af...
1. Lay the back side of the hood flat on a table. Use a piece of cardboard to avoid damaging the table or the hood. 2. Remove the grease filters by pulling down the metal latch tab and tilting filters downward to remove. 3. Align the hood and center it above the hood mounting bracket. Gently lower t...
8. Grease filters 1. To remove the grease filters, pull down on the metal latch tab and tilt each filter downward to remove. 2. To install the grease filters, align rear filter tabs with slots in the hood. Pull down the metal latch tab, push each filter into position and release. Make sure filters a...
Grease filters grease filters should be cleaned monthly. Remove grease filters by pulling down on the metal latch tab. This will disengage the filter from the hood. Tilt the filter downward and remove. Use a warm detergent solution to clean the filters. Let them dry and reinstall them. Hood cleaning...
12. Service parts key no. Part no. Description quantity 1 07250 decorative upper and lower flues 1 2 07243 motor & blower assembly 1 3 07244 light assembly 2 4 07245 push button assembly 1 5 07759 aluminum grease filters 2 6 07251 curved glass plate 1 7* 07252 curved stainless steel plate with rail ...
Venmar jazz range hood 1-year limited warranty venmar ventilation inc. Warrants to the original consumer purchaser of its products, that such products will be free from defects in materials or workmanship for a period of one (1) year from date of original purchase. This warranty includes in-home ser...
