Hb0074 08382 rev. 04 chimney range hood model vj70330ss intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: use and care information on page 10. Venmar ventilation inc., 550 lemire blvd., drummondville qc j2c 7w9 1-800-567-3855 register your product on line at:...
! To reduce the risk of fire, electric shock, or injury to person(s) observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning uni...
- 3 - 1. Measure the installation and install ductwork the minimum hood distance above cooktop must not be less than 24” for best capture of cooking impurities. Decide where the ductwork will run between the hood and the outside. A straight, short duct run will allow the hood to perform most efficie...
- 4 - grounding instructions this appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug...
4. Install hood mounting bracket locate the top of the wood wall framing at 47” from cooktop (see illustration at right). Once wall surface is finished, carefully trace a center line over installation location, then trace a level line at 45” from cooktop. Center and level the hood mounting bracket, ...
1. Place the hood on a table. Use a piece of cardboard to avoid damaging the table or the hood. Using 4 no. 8 x 5/16” screws, mount the metal air outlet to the top of the hood. Remove all protective plastic film on the hood. 2. Remove protective plastic film on the lower flue and install it over the...
6. Install the hood (cont’d) 4. Carefully assemble the glass panel to the hood, using the 4 special screws with spacer. Note: if installing this hood in a 9-ft. Ceiling kitchen, the extension flue (model no. 07634) must be installed prior to continue the hood installation. Refer to extension flue in...
7. Slide a 6” steel round duct over the metal air outlet, use metal foil duct tape to seal the joint. Plug the hood power cord into the outlet. 8. Slide up the upper flue until it is aligned with its mounting bracket. The bracket should be inside the flue. Secure the upper flue on the upper flue mou...
7. Reinstall grease filter to reinstall the grease filter, align down filter tabs with slots in the hood. Press down the metal latch tab, push filter into position and release. Make sure the filter is securely engaged after installation. Close the hood front panel. 11. Drill both screw holes using a...
- 10 - 9. Operation the hood is operated using the push button on the front panel. The light switch turns the lamps on and off. The blower switches turn the blower on to three speed settings: low speed medium speed high speed hc00 3 6 off low med. High on/off fan controls lights grease filter grease...
- 11 - 11.Replacement parts key no. Part no. Description quantity 1 08390 flue cover kit 1 2 08487 metal air outlet 1 3 08584 brackets set 1 4 08386 glass 1 5 07243 motor and blower assembly 1 6 08384 aluminum grease filter 1 7 07244 light assembly 2 8 07245 push buttons assembly 1 * sv20601 halogen...
- 12 - warranty venmar jazz range hood 1-year limited warranty venmar ventilation inc. Warrants to the original consumer purchaser of its products, that such products will be free from defects in materials or workmanship for a period of one (1) year from date of original purchase. This warranty incl...
