Vj71130ss chimney range hood installation instructions intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: use and care information on pages 10 and 11. Read and save these instructions venmar ventilation inc., 550 lemire blvd., drummondville qc j2c 7w9 1-800-56...
2 to reduce the risk of fire, electric shock or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit,...
3 warranty venmar jazz range hood 1-year limited warranty venmar ventilation inc. Warrants to the original consumer purchaser of its products, that such products will be free from defects in materials or workmanship for a period of one (1) year from date of original purchase. This warranty includes ...
4 1. Install ductwork warning ! When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves. Plan where and how the ductwork will be installed. A straight, short duct run will allow the hood to perform most efficiently. Long duct runs, elbows and...
5 3. Prepare installation note: before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the retailer. Make sure that the following items are included: - hood - curved glass panels (installed on the hood) - micromesh filter - decorative flue asse...
6 5. Prepare hood location 1. Construct wood wall framing that is flush with surface of wall studs. Ensure: a) the framing is centered over installation location and is sturdy enough to support the weight of the hood. B) the height of the framing will allow the hood to be secured to the framing with...
7 8. Install hood warning ! Be careful when installing the decorative flue and hood, they may have sharp edges. Caution do not remove the protective plastic film covering the decorative flue (upper and lower) and the hood yet. 1. Place the hood at its location. Using a pen, mark the position of both...
8 9. Grease filter to remove grease filter, open the hood front panel ( a ), then remove the grease filter by pressing down on its metal latch tab and tilting filter downward ( b ). To reinstall grease filter, align filter tabs with slots in the hood. Press down the metal latch tab, push filter into...
9 caution • when reinstalling, the curved glass panel retaining screws must be hand tighten only to prevent glass breakage. • ensure not to pinch wires when reinstalling the curved glass panel. 10. Light bulbs ( cont ’ d ) 3. Squeeze both springs ( d ) and push light assembly down ( e ). Remove ligh...
10 11. Operation 1 1) lighting push button 2) led push button 3) blower on/speed increase push button 4) blower off/speed decrease push button always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the air after you tu...
11 12. Care grease filter grease filter should be cleaned monthly. Remove grease filter by pressing down on its metal latch tab. This will disengage the filter from the hood. Tilt the filter downward and remove. Use a warm detergent solution to clean the filter. Let it dry and reinstall it. Grease f...
12 13. Replacement parts hl0202 1 2 4 5 10 6 7 8 3 9 r eplacement p arts and r epairs in order to ensure your ventilation unit remains in good working condition, you must use venmar ventilation inc. Genuine replacement parts only. Venmar ventilation inc. Genuine replacement parts are specially desig...
