Venstar ACC0400 Installation instructions
OUTDOOR LOCATION The Outdoor Sensor should be mounted on the north side of the building, out of direct sunlight,
and in a place that is protected from direct rain and snow. Mounting the sensor under an eave of a roof or under an
overhang of a building is recommended.
INDOOR LOCATION The Outdoor Sensor should be mounted approximately five feet from the floor, close to or in a
frequently used room, preferably on an inside partitioning wall or on a section of wall without pipes or ductwork. Mount
the sensor where temperature operating limits are within 32 to 99 F and where humidity operating range is within 0 to 95%
relative humidity, non-condensing.
INCORRECT LOCATIONS The Outdoor Sensor should NOT be mounted close to a window, on an outside wall, or next
to a door leading to the outside. Do not mount the sensor in a location where it would be exposed to direct light and heat
from a lamp, the sun, a fireplace, or any other temperature-radiating object which may cause a false reading. Finally, do
not mount the sensor close to or in direct airflow from supply registers or return air grilles and in areas with poor air
circulation (such as behind a door or in an alcove).
IMPORTANT: READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING THE SENSOR.
DIGITAL OUTDOOR
TEMPERATURE SENSOR
Sensor Location
Wiring Requirements
CAT 5 Cable
Thermostat Cable
The
Sensor should be connected to the thermostat using solid conductor CAT 5, CAT 5e, or CAT 6 type network
communication cable. This is an unshielded cable with four twisted pairs of 24 gauge solid wire; DO NOT use stranded
cable. The cable length should not exceed 250 feet. If less than 75 feet of cable is required to connect the thermostat to
the Outdoor Sensor, a three conductor thermostat cable (18-24 gauge) may be used; this cable is NOT suitable for any
length greater than 75 feet.
IMPORTANT: Do no use shielded wire. Do not run sensor wiring in the same conduit as the 24VAC thermostat wiring.
Electrical interference may cause the sensor to give incorrect temperature readings.
Outdoor
NOTE: All sensor wiring must be in compliance with all applicable local and national codes.
SAFETY CONSIDERATIONS
Read and follow the manufacturer instructions carefully. All wiring must conform to local and national
electrical codes. Improper wiring or installation may damage the sensor.
Recognize safety information. This is the safety alert symbol . When the safety alert symbol is present on
equipment or in the instruction manual, be alert to the potential for personal injury.
Understand the signal words DANGER, WARNING, and CAUTION. These words are used with the safety alert
symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death.
WARNING signifies a hazard which could result in personal injury or death. CAUTION is used to identify
unsafe practices which may result in minor personal injury or property damage.
The Outdoor Sensor measures indoor or outdoor air temperature with a range of -40 to 127 F. If used indoors
as a remote temperature sensor, the sensor will read room temperature and send the information to the
thermostat. If used as an outdoor temperature sensor, the sensor may be used to provide outdoor
temperature information (which is not used to control heating or cooling).
GENERAL
©Venstar Inc. 08/07
P/N 88-623 Rev. 1
ACC0400
MODEL