Vent-a-Hood CWEH6-K Installation Instructions Manual - page 5
Page 5
L151 0310A
Installation Details Continued
11) FOR BACK VENTING APPLICATIONS ONLY. IF NOT BACK VENTING, PROCEED DIRECTLY TO STEP 12.
Place the appropriate elbow on the top of the hood. The elbow should be placed with the non-crimped end on the inside
the collar of the exhaust outlet. Use duct tape to seal joints.
Insert the electrical wire from the service panel into the electrical wire clamp on the rear of the hood. Tighten the wire
clamp. While securing the slack in the electrical wire, lift the hood and duct cover assembly up to the wall and hang
the hood on the mounting strip, taking care to properly align the duct connection between the elbow and the duct in
the wall.
Warning: Do not operate hood without proper ground connection.
Secure the hood to the mounting strip by installing the screws (previously removed from the strip in Step 8) into the
pilot holes drilled in Step 10.
SKIP STEP 12. PROCEED DIRECTLY TO STEP 13.
12) Insert the electrical wire from the service panel into the electrical wire clamp on the rear of the hood. Tighten the wire
clamp. While securing the slack in the wire, lift the hood up to the wall and hang the hood on the mounting strip, taking
care to properly align the duct connection between the hood and the duct in the ceiling.
Warning: Do not operate hood without proper ground connection.
Secure the hood to the mounting strip by installing the screws (previously removed from the strip in Step 8) into the
pilot holes drilled in Step 10.
13) From inside the hood, using UL listed wire nuts, attach the “neutral” wire to the white lead, the “hot” wire to the black
lead, and the ground wire to the green lead.
14) Refer to the Owner Maintenance Guide Operating Instructions for proper hood operation. Test all blower and light
functions to ensure they are operating properly.