VENT-A-HOODS PWD14 EUROPA Installation Instructions
FOR PWD14 EUROPA VENT-A-HOODS
INSTALLATION INSTRUCTIONS
A. Installation Work and Electrical Wiring Must Be Done By
Qualified Person(s) In Accordance With All Applicable
Codes And Standards, Including Fire-Rated Construction.
B. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
C. Ducted fans must always be vented to the out-
doors.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
D. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturers guideline and safety
standards such as those published by the NationaI Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and local code authorities.
Read and Save These Instructions
Turn Page For More Instructions
All Hoods Should Be Installed By A Qualified Installer
CEILING
Step 2 . . .
Remove wood strip from rear of
hood and secure to the wall at
proper mounting height. Bottom of
hood should be 24 to 27 from
cooking surface.
Step 3 . . .
Install duct work on top
of hood. Make sure
length is sufficient to
connect to duct work in
ceiling.
Step 1 . . .
Remove hood and duct
cover from wood pallet and
set on a protected surface.
Step 5 . . .
Lift fully assembled unit to wall and hang hood on wood strip.
Secure hood to wall with proper fasteners. You may have to drill
new mounting holes in back of hood to line up with studs. The
crimped end of the duct pipe should be facing towards ceiling
as you lift hood into position. The back of the duct cover should
lay flat against the wall and does not generally need to be
secured at the top.
DUCT
COVER
WOOD STRIP
BACK
VIEW
DUCT PIPE
LIFT HOOD, DUCT PIPE, AND DUCT
COVER UP TO MOUNTING LOCATION
AS ONE UNIT
BACK
VIEW
DUCT
DUCT PIPE
COVER
DUCT
COVER
Step 4 . . .
Install duct cover to top
of hood with bolts
provided.
WIRING