Vent-Axia HR500IP Installation instruction

Summary of HR500IP

  • Page 1

    Copyright © 2009 vent-axia limited. All rights reserved. Hr500ip passive semi-remote wall mounted heat recovery unit with spigot connections. Installation instructions stock ref. N° 370447 - hr500ip please retain these instructions with the product..

  • Page 2

    Warnings & safety information 2 important safety information please read these instructions carefully before commencing installation. 1. Do not install this product in areas where the following may be present or occur: • excessive oil or a grease laden atmosphere. • corrosive or flammable gases, liq...

  • Page 3

    3 external extract grille external inlet grille introduction the vent-axia hr500ip unit is designed for mounting in internal walls for installations using ducted extraction and fresh air supply. Air movement is achieved by using in-line duct fans or wall mounted units to suit the length and configur...

  • Page 4

    4 installation the hr500ip unit should be set in an inner wall with the grille flange set flush with the inner surface (a steel lintel is provided for additional support of the building fabric if required). If used this will automatically produce a 3° slope of the unit away from the inner grille for...

  • Page 5

    5 maintenance & cleaning the hr500ip unit requires only occasional cleaning. By depressing the two buttons on either side of the internal grille, the grille, pre-filters and heat exchanger can be easily removed and cleaned by using a vacuum cleaner or by washing in luke warm soapy water. In heavily ...

  • Page 6

    6 activating the timestrip. 1. Activation: fully squeeze the activation button between thumb and finger. A red line will appear within 1-2 minutes to show that the timestrip has been activated. 2. Peel off the backing liner and stick the timestrip to the unit or near the controls of the unit. The lo...

  • Page 7

    Product fiche 7 product fiche for residential ventilation units (complying commission delegated regulation (eu) no 1254/2014) name: vent-axia model id (stock ref.) : hr 500 ip - 370447 sec class a sec value ('average') -39.00 sec value ('warm') -17.84 sec value ('cold') -76.72 label required? (yes/n...

  • Page 8

    Guarantee and contact information 8 head office: fleming way, crawley, west sussex, rh10 9yx. Uk national call centre, newton road, crawley, west sussex, rh10 9ja sales enquiries: tel: 0344 8560590 fax: 01293 565169 technical support tel: 0344 8560594 fax: 01293 532814 for details of the warranty an...