Summary of FINO
Page 1
Fino assembly and installation manual of ceiling fan.
Page 2
Installation must be carried out by a qualified electrician. Turn off the electrical mains at the circuit breaker/fuse box. Do not use power supply other than 220v / 50hz. This appliance must be earthed. When mounting the fan, ensure that the safety wire is looped across the mounting bracket . The m...
Page 3
Mounting bracket downrod set canopy fan body blades . . . . . A b c d e . G screw pack screws for mounting bracket x2 wire connector x3 h i . . . F remote control transmitter transmitter cover receiver wall bracket for transmitter battery instruction manual for remote control accessories packet . . ...
Page 4
Floor 2 . 3 m mounting bracket screws ( h.) 1. Attention: do not install the fan onto the partition ceiling or chapped wall. The ceiling fan must be mounted at a min. Height of 7.5ft/2.3m of clearance from the floor. Iii. Installation instruction 2. The mounting bracket must be securely fastened to ...
Page 5
Screw loosen screws at the side of the center of blades, push the blade into the axle. Tighten the screws. 5. Insert wire and safety wire through the downrod set. Fit one end of the downrod, with no ball attached, to the top portion of the “u” tube. Put the washer through the downrod screw. Then put...
Page 6
Adjust the angle into proper position, then tighten the screws. 0° set screw 45° set screw 90° set screw 6. Check if the mounting bracket is properly and securely installed, then place the assembled fan onto the mounting bracket. Mounting bracket downrod set canopy 7..
Page 7
The ball at the top of the downrod allows the fan to face six directions, confirm a direction before placing the ball onto the mounting bracket. As shown in the diagram below. Tighten the two downrod set screws to make sure the fan run stably. Then, install downrod (ball part) into mounting bracket ...
Page 8: Fan Remote Control
Iv. Installation instructions for ceiling fan remote control a. Important points: b. Operation instructions: c. Functions of transmitter: 1. 2. 3. 4. 5. 6. 7. 8. Please read this manual and keep it for future use. Turn off the electrical mains at the circuit breaker/fuse box. Please note that all wi...
Page 9: V. Code Switch Setting
Receiver antenna 9v ba tter y 1 2 3 4 on dip dip switch to open battery cover slide down the cover according to the arrow direction. V. Code switch setting 1. 2. 3. 4. 5. 6. These dip code can be pushed upward and downward to change the setting. Both of these remote control components (receiver and ...
Page 10
Fig 2 complete diagram code switch antenna (do not attempt to shorten the receiver’s antenna wire.) red (ac in/live) white (ac in/neutral) ac power input brown (fan/live) blue (mains/neutral) black (antenna) green/yellow (ground wire) vi. Wiring for ceiling fan installation note: a.) incorrect wire ...
Page 11: Vii. Fuse Replacement
Vii. Fuse replacement completes the chart 5a fuse latch assemble chart vii. Fuse replacement push both side of the fuse capsule towards each other and twist it to open the fuse capsule. Remove the damaged 5a glass fuse from the capsule then replace a new 5a glass fuse. To close the fuse capsule alin...
Page 12: Viii. Trouble Shooting
Problem a: fan will not start remedies: 1. 2. 3. Check fuse or circuit breaker and replace if necessary. Turn off electrical power, check all wire connections. Check to make sure the dip switches from the transmitter and receiver are set on the same frequency. Problem b: fan excessively noisy remedi...
Page 13
B40517b ke.