Bucket fan series bucket fan whisper series user’s manual bucket fan 420 bucket fan 1055 bucket fan 1460 bucket fan whisper 420 bucket fan whisper 1055 bucket fan whisper 1460
2 bucket fan bucket fan content i ntroduction 3 u se 3 w hat ’ s included in the box 3 d esignation key example 3 s ize r anges 3 s afety r equirements 4 m ounting and i nstallation g uidelines 5 b ucket f an p arts 7 m aintenance 8 w iring the f an 8 t roubleshooting 11 s torage 11 w arranty 12.
3 introduction use what’s included in the box one bucket fan or bucket fan whisper one users manual one set of hanging/safety gripples controller (if ordered) this manual will provide you with installation, operation, and service instructions, as well as technical data of the bucket fan series and b...
4 bucket fan bucket fan fig. 1 safety requirements during installation and operation, observe all codes and safety standards for your locale. Always make sure the electricity is disconnected at the main power source prior to connection, adjust- ment, servicing and/or repair operations. Electrical co...
5 mounting and installation guidelines prior to installation: read and understand this entire manual. Should you have any questions before, during, or after installation please call your seller or contact vents at 888-640-0925 or install@ventsus.Com. Check the product for any damage that may have oc...
6 bucket fan bucket fan fig. 3 tip: it is easier to attach the hanging cable and gripple to the structure fi rst and then attach the fan with the toggle. 1) insert the cable into one of the openings in the gripple 2) place the cable over the i-beam, truss, or other structure from which it is being h...
7 bucket fan parts the bucket fan can be angled if needed. All it takes is a 13 mm socket wrench. Loosen the bolts on either side of the fan, place at the angle you want, then re-tighten the bolts. 1) electrical junction box on protective grille. 2) vibration absorbing mount 3) metal case 4) handle ...
8 bucket fan bucket fan before performing any maintenance always ensure that there is no power to the fan, you must disconnect the electricity at the main power source! Annually: 1) check to make sure the bolts are tight. 2) check impeller for dirt or other matter. Clean if necessary. • to clean, re...
9 fig. 7 controller wiring and installation • the following is for the installation of one controller for one fan. Contact vents us if you need to operate two or more fans with one controller. • refer to figure 7 for electrical connections. • use 18 awg or greater wire. • it is important that the co...
10 bucket fan bucket fan 1. Application a) motor type – shaded pole, p.S.C. And universal. B) required load – fans, blowers and speed dependent loads. 2. Wiring warning! Power must be turned off before wiring. Connect control in series with motor and line volt- age; never connect control across line...
11 model possible reason remedy the fan does not start no power have a qualifi ed electrician check connections and power source. The fan does not start (pos- sibly with humming noise) object stuck in blades turn off power. Remove object. Restart fan. Loud noise, vibration loose screw dirty impeller...
12 bucket fan bucket fan warranty vents us warrants to the original purchaser of the bucket fan series series fan that it will be free from defects in materials or workmanship for a period of 60 months from the date of original purchase. If the fan is installed with the speed controller the warranty...
