Vents Micra 150 E User Manual - page 11
11
To reset the unit to the factory settings, enter the fan speed setup
mode, synchronously press and hold the buttons and for 3
seconds.
Factory fan speed settings:
low speed — 40 %
medium speed — 70 %
high speed — 100 %
Fig. 12. Fan speed setup
Fig. 13. Filter replacement signal
7. filter replacement signal.
As the filter service life expires (3000 hours) the control panel displays a filter replacement indicator , instead of the operating
temperature, fig. 13.
In case of the filter replacement signal turn the unit
off with the button
and disconnect it from power mains. Then
replace the filters following the filter replacement procedure in the
section «Technical maintenance», page 14.
After that press the button
on the control panel or
the button
on the remote controller to turn the unit on.
Then press synchronously the buttons
and
to reset the
motor meter.
8. Date and time setup.
Turn the unit off.
Press and hold the button
, then press the button
on the control panel to enter the date and time setup mode.
Keep the button
, pressed and select a parameter to be edited using the buttons
and
. An editable parameter blinks.
The date and time setup parameters are located as listed:
1. Minutes;
2. Hours;
3. Weekday;
4. Date;
5. Month;
6. Year.
Then set the required parameter with the buttons
and
on the control panel.
Press the button
to exit the date and time setup mode..
9. Time scheduled operation.
Press and hold the button
, then press the button
on the control panel to activate the time-scheduled operation. The
indicator
confirms that the unit time-scheduled operation is activated.
Press and hold the button
, and then press the button
on the control panel to deactivate the time-scheduled operation.
Press the button
on the remote controller to activate or deactivate the unit time-scheduled operation.
The timer control has higher priority with respect to the time-scheduled operation.