1. DL manuals
  2. Ventur
  3. Heating System
  4. IDEO - 275 Ecowatt
  5. Installation Manual

Ventur IDEO - 275 Ecowatt Installation Manual

Manual is about: High-performance heat recovery dwelling unit

Summary of IDEO - 275 Ecowatt

  • Page 1

    Ctb ideo - 275 ecowatt installation manual.

  • Page 2

    Before manipulating this device, disconnect the electricity supply. During normal operation, never stop the ventilation system..

  • Page 3

    General information high-performance heat recovery dwelling unit 1 introduction this manual is destined for use with the ideo 275 ecowatt high performance heat recovery unit and its this manual is destined for use with the ideo 275 ecowatt high-performance heat recovery unit and its peripheral fitti...

  • Page 4

    2 technical information 2.1 general definition the ideo 275 ecowatt provides optimum ventilation for a room with a minimum loss of energy. It extracts air from spaces such as (bathroom/s wc kitchen and washroom/s or shower room/s and extracts air from spaces such as (bathroom/s, wc, kitchen and wash...

  • Page 5

    New fresh air inlet: the conduit from the outside is connected here. To avoid condensation, it is recommended to use insulated conduits. The new fresh air inlet should be fitted sufficiently far from any source of strong the new fresh air inlet should be fitted sufficiently far from any source of st...

  • Page 6

    2.3 dimensions central unit: weight: 51 kg remote controls: programmable module kitchen boost.

  • Page 7

    Wall bracket 2.4 placement on a vertical wall: on the floor: it is recommended to locate ideo in heated house space. Otherwise it will be necessary to insulate the condensate drain pipework...

  • Page 8

    On the floor: an specific kit option support it is recommended to locate ideo in heated house space. Otherwise it will be necessary to insulate the condensate drain pipework necessary to insulate the condensate drain pipework. Tube cover: 4x 4x.

  • Page 9

    Diagram of standard assembly type “delivery” kitchen outlet roof caps ct 150 toilets bdop 125 bdop 80 toilets air intake plenum pap air intake d150 li i / itti or paf 150 circular air intake wall hoods living/sitting room & bedrooms or or past air intake roof d150 10 spigots distributor.

  • Page 10

    Outlet roof caps diagram of standard assembly type “distribution” outlet roof caps ct 150 living/ sitting room bdop 125 kitchen bdop 125 bdop d80 + + rd80 bedrooms toilets bar + toilets pap air intake d150mm bdop d80 + rd80 + or paf 150 circular air intake d150mm or or past air intake roof hoods d15...

  • Page 11

    Do not start the central until all the ducts are all completely fitted (air inlet, retaining grille or roof outlet, supply and extraction outlets, ducts and filters fitted) and filters fitted) when started, the central ideo automatically adapts to the specific characteristics of each installation. I...

  • Page 12

    .2.3 controlling the ideo 275 ecowatt the ideo 275 ecowatt can be controlled from: • a button that enables the boost flow for the kitchen to be timed in ½-hour steps. Service life with normal usage (average 3 times a day) is estimated to be about 4 and a half years. For each operation, a red signal ...

  • Page 13

    2 2.2.A . Description of the programming module: 5 6 7 8 9 1 3 4 10 11 12 14 12 17 16 1 – adjustment mode using the clock 2 p i d (a t ti 1 a t ti 2 m l) 15 13 20 19 18 2 – programming mode (automatic 1 – automatic 2 – manual) 3 – day of the week 4 – programming period 5 – ventilation speed (small o...

  • Page 14

    2.2.B . Functions of the programming module: (1) • adjustment using the clock: navigate with keys 19 or 20 to pictogram 1 showing a clock. Select with key 18 the pictogram will flash validate with key 18 select with key 18. The pictogram will flash. Validate with key 18. Adjust the desired hour usin...

  • Page 15

    - auto 2: working week with three meals per day and the weekend, starting breakfast two hours later. Start finish start finish start finish day t1 t2 t3 monday 6:30 7:30 12:00 13:00 19:30 20:30 tuesday 6:30 7:30 12:00 13:00 19:30 20:30 wednesday 6:30 7:30 12:00 13:00 19:30 20:30 thursday 6:30 7:30 1...

  • Page 16

    • conditions for the filter icon to be displayed (12): this icon will be displayed when one or several filters are soiled and it is necessary to clean or replace them. 9 f1 = blowing filters 9 f 2= extraction filters the time it takes for the filter to become soiled can be highly variable according ...