Verbatim Wireless Slim Keyboard and Mouse Quick Start Manual - Let’S Get
2. Plug receiver into USB port.
a. Wait for PC to recognize new hardware.
b. Mouse and receiver will connect automatically.
Note: If mouse or keyboard does not operate, follow
the steps below to establish a connection separately
for each device.
Keyboard
Step 1 While the receiver is connected to the USB port
press the connect button and a green light will flash.
Step 2 Immediately following Step 1, press the
connect button located on the underside of the
keyboard marked “Connect.” Wait a few seconds, the
green light will stop flashing to indicate a connection
is established and the keyboard will operate correctly.
3. Install software.
Let’s Get
Started
Mouse
Step1. While the receiver is connected to the USB port press the connect button and
a green light will start to flash.
Step 2 Immediately following Step 1, press the connect button located on the
underside of the mouse, wait a few seconds, the green light will stop flashing to
indicate a connection is established and the mouse will operate correctly.
5