Summary of VX-TW
Page 1
Vx-tw vx series wireless thermostat with an occupancy sensor installation manual v.1 june 26, 2017.
Page 2
3 table of contents introduction .................................................................................................4 thermostat installation ...............................................................................6 pairing the thermostat and the control card ......................
Page 3
4 5 introduction verdant vx series energy management thermostats for the hospitality industry deliver unprecedented energy savings without compromising guest comfort. An integrated occupancy sensor uses a combination of motion and thermal sensing technologies for accurate occupancy detection. Reliab...
Page 4
6 7 before you begin ➤ determine the appropriate installation location for the thermostat. ➤ set the hvac unit to “external thermostat” (class 2) mode. Consult the hvac unit documentation to determine how to set the hvac unit to “external thermostat” mode. ➤ consult hvac manufacturer’s documentation...
Page 5
8 9 thermostat installation note: if the ptac unit has only one (1) fan speed, connect both fan control wires – green and purple – to the fan terminal (g). Wiring table - 24v ac wire color terminal letter terminal connection black c common red r 24v yellow y compressor white w heat orange o or b rev...
Page 6
Configuration button note: you can access thermostat configuration settings at any time by pressing the “configuration” button. 10 11 thermostat configuration once the thermostat is powered, thermostat configuration settings will appear on the thermostat screen. In order to properly operate the hvac...
Page 7
12 13 thermostat configuration entering the room number enter the room number by changing the digits on the screen. Leading zeros “0” preceding other digits will be ignored, i.E. Room number “123” should be entered as “00123”. ➤ use the “up” and “down” buttons to change the digit; ➤ press the “fan” ...
Page 8
14 15 thermostat configuration configuring the equipment settings - electric heat ➤ use the “up” and “down” buttons to change the electric heat setting by changing the second digit; 0 no electric heat 1 * electric heat ➤ press the “fan” button to advance to the next setting; * indicates default sett...
Page 9
16 17 thermostat configuration configuring the energy saving settings ➤ use the “up” and “down” buttons to select the energy saving preset: e-0 * energy savings off - no temperature setback; e-1 lowest energy savings; e-2 lower energy savings; e-3 standard energy savings; e-4 higher energy savings; ...
Page 10
18 19 thermostat maintenance replacing thermostat batteries the low battery indicator will be displayed on the thermostat screen when it is necessary to replace batteries in the thermostat. Under normal operating conditions, new brand-name alkaline batteries will last for a period of approximately o...
Page 11
20 21 the thermostat is not controlling the hvac unit. Check if the hvac unit is set to “external thermostat” (class 2) mode. Verify the status of the red light on the wireless control card; ➤ the red light is off the wireless control card is not powered. Verify that the wireless control card is pro...
Page 12
22 23 “automatic fan control mode” - fan runs only when there is a demand for heating or cooling; “manual fan control mode” - guest can select between automatic or continuous fan operation; “minimum set point” - minimum temperature that a guest can request; “maximum set point” - maximum temperature ...
Page 13
English this device complies with industry canada license-exempt rss standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the devic...