1. DL manuals
  2. VeriFone
  3. Printer
  4. Printer 900
  5. Installation Manual

VeriFone Printer 900 Installation Manual - Installing The Printer 900

Manual is about: VeriFone Installation Guide Printer 900

Summary of Printer 900

  • Page 1

    Printer 900 installation guide.

  • Page 2

    Table of contents introduction ..............................................................................................................3 key features ....................................................................................................3 unpacking the printer 900....................

  • Page 3: Introduction

    Introduction the printer 900 is a high-performance, freestanding dot-matrix roll printer for verifone terminals or computers equipped with an rs-232 serial port. Capable of printing up to 42 characters per line, it is ideal for printing receipts or data on one-, two-, or three-ply carbonless 76-mm w...

  • Page 4

    Figure 1. Printer 900 components 2. Place the printer on a solid desk or table top. When choosing a location for the printer, avoid areas with • direct sunlight or objects that radiate heat • excessive moisture • excessive dust • devices that cause excessive voltage fluctuations or electrical noise ...

  • Page 5

    Setting the internal dip switches a set of four dip switches is located under the paper holder on the bottom of your printer 900. Make sure that these switches are set as indicated below before connecting and operating the printer. The printer will not operate properly if the switches are not set co...

  • Page 6: Installing The Printer 900

    Installing the printer 900 caution: unplug the terminal’s power pack before con- necting the printer 900 to the terminal. Before installing the printer 900, you must have the correct printer interface cable. The accessories section, located on the last page of this installation guide, lists the inte...

  • Page 7

    Installing or replacing the ribbon cartridge 1. Remove the ribbon cover by pressing the front tab and lifting the cover up. 2. If you are replacing an old ribbon, pull up on the lift tab on the right side of the cartridge (see figure 6), remove the cartridge and discard it. 3. Remove the new ribbon ...

  • Page 8

    Installing the paper roll the printer 900 accepts paper that is 76mm wide. There are three different types of roll paper available from verifone. These are listed in the accessories section on page 11. Note: for best results, be sure the leading edge of the paper roll is cut cleanly rather than torn...

  • Page 9

    Figure 8. Installing the paper roll (exploded view) roll cover paper roll paper feed button paper support arms paper roll core paper cavity paper feed path to engage the auto feed mechanism, gently guide paper end into paper feed path. As soon as the sensor detects the paper, the printer automatical...

  • Page 10: Cleaning

    Running the print test 1. Disconnect the power cord at the rear of the printer. 2. Hold down the paper feed button and plug the power cord back into the printer. Release the feed button when printing begins. The printer will stop automatically after printing 100 lines of the u.S. Character set. Remo...

  • Page 11: Printer Specifications

    Printer specifications power requirements voltage: 90 vac–137 vac, 47–60 hz (low voltage version) 180 vac–274 vac, 47–60 hz (high voltage version) power consumption: 45w max @ 100vac input; 0.5 amp (average) @ 120 vac input dimensions and weight height: 94.5 mm (3.72 in.) width: 156.0 mm (6.1 in.) d...

  • Page 12: Accessories

    Accessories verifone part no. Description ribbon cartridges crm0023 red/black crm0025 purple roll paper crm0008-01 paper, 11 mm core 2-ply p250/500/900r crm0008-02 paper, 11 mm core 3-ply p250/500/900r crm0008-03 paper, 11 mm core 1-ply p250/500/900r supply kit 25052-01 10 rolls of paper, 1 ribbon (...