Verilux CleanWave VH01 User Manual - Sanitizing Wand Operation
10
Sanitizing Wand Initial Set-up — continued
Charging the Wand
It takes approximately 14 hours to fully charge the
battery for the first time.
• Connect the power adapter to the Wand.
• Plug the power adapter into a 110V grounded
electrical outlet.
• The status LED light is RED when the Wand is
charging.
• The status LED light is GREEN when the Wand is fully
charged or in use.
• After the first full charge, typical charging time is 8
hours under normal use. The Wand can be used for
up to 1 hour when fully charged.
Only the wand adapter provided with
the device should be used.
Low Battery Indication
When the battery is low and requires charging, the Wand will beep 10 times
and the red LED will flash 10 times.
LED Indicator Status
•
Flashing Red – the Wand needs to be recharged.
•
Red – the Wand is charging.
•
Green – the Wand is fully charged or the Wand is on.
Sanitizing Wand Operation
Timer
During operation, a count-up timer shows total sanitizing
time. The display increments each second to 59, then
briefly displays the minutes elapsed before starting
another 59-second count-up. The next minute reached
is then shown briefly and the count-up begins again.
This cycle repeats for 99 minutes or until the Wand
requires charging.
To see the current minute of sanitizing time, quickly
press and release the blue button.
Timer
Pr
ess
Button for M
in
s
To Start,
Press Until
Beep
CAUTION:
VH01_MAN_Rev21.indd 10
7/31/13 2:03 PM