Verilux CleanWave VH07 User Manual - Initial Set-Up
8
Initial Set-up
Vacuuming with UV-C
1. Attach the vacuum cleaner to
the base unit. Insert it into the
base unit and then press the
rear down firmly. Press lever
down when docking vacuum.
Then pull up until lever clicks
twice to lock (see Figure 1).
2. Turn on the cleaner using the
on/off switch.
The UV-C bulb will turn on when
the UV-C safety switch is in
contact with the surface to be
cleaned. You can confirm that the
UV-C light is on by checking the
confirmation windows on the top of the unit (A).
Avoid vacuuming fine dust, such as cement and plaster, as this will block the
filters. If fine dust is picked up, the filters, collection cup and tools must be
thoroughly cleaned immediately after use.
Using the Handheld Vacuum Only
1. Turn the cleaner off using the on/off
switch.
2. To remove the cleaner from the base,
press the lever at the rear of the
vacuum base (see Figure 1).
3. Lift the handheld vacuum from the
base.
Certain tasks may require the use of the
nozzle or brush attachments. These tools
are stored in the base unit (see Figure 2).
Figure 1
A
A
Figure 2
Lock/Release
Lever
Nozzle
and brush
attachments
Always direct the UV-C light AWAY from the eyes and skin.
Direct prolonged exposure of eyes or skin to the UV-C light bulb can cause
serious skin burn and eye inflammation from short wave ultraviolet radiation.
Radiation from these lamps is harmful to the eyes and skin.
Do not override the safety switches manually.
Do not attempt to pick up large or sharp objects as these may
cause damage to the vacuum cleaner.
CAUTION:
CAUTION:
DANGER:
VH07-Man-Rev19.indd 8
9/8/11 8:33 AM