1. DL manuals
  2. Verilux
  3. Indoor Furnishing
  4. Floor Lamp
  5. Instruction Manual

Verilux Floor Lamp Instruction Manual

Manual is about: Verilux Instruction's Manual Floor Lamp

Summary of Floor Lamp

  • Page 1

    ? Please visit our web site at: www.Verilux.Net call our client relations department at 1-800-786-6850 (representatives are available monday - friday, 9 am - 5 pm eastern) please visit our web site at: www.Verilux.Net call our client relations department at 1-800-786-6850 (representatives are availa...

  • Page 2

    • do not dismantle. • do not alter power cord. • do not use lubricating agent in assembly; please see troubleshooting section or call client relations if you are having difficulty assembling your lamp (1-800-786-6850). • unplug from electrical outlet for extended periods of non-use or during lightni...

  • Page 3

    Unpacking your lamp 4 1. Remove all pieces from box. Locate 2 screws and tightening tool. 2. Detach red plastic pieces and store them in the event you need to return the lamp. 3. Important: to avoid scratching the metal shaft, do not use a sharp object to cut the plastic covering. The clear plastic ...

  • Page 4

    Assembly instructions (continued) 6 4. Attaching the parabolic grid diffuser • remove grid diffuser from protective plastic bag • insert plastic pegs at bottom of grid diffuser into openings near bulb socket • snap tab into place 5. Plug lamp into outlet and turn on; if bulb does not illuminate inst...

  • Page 5

    Correctly seated bulb incorrectly seated bulb bulb replacement instructions 7 removal 1. Unplug lamp from power source. 2. To access to the bulb, remove grid diffuser by depressing the tab and lifting it out. (see page 6) 3. Firmly hold bulb base (b) and pull bulb (c) from the socket (a) in an outwa...

  • Page 6

    Troubleshooting 9 • make sure all power connectors, cords, and plugs are inserted fully and securely. • be sure the bulb is securely seated into the socket. (see page 7) • unplug the lamp for a few minutes (this allows the electronic ballast inside the lamp to reset). • make sure there is power to t...