Summary of Planet Light PL04
Page 1
Pl04 planet light ® energy saving natural spectrum ® floor lamp.
Page 2
2 dear customer, thank you for purchasing the planet light ® energy saving natural spectrum ® floor lamp. You have received a quality product, backed by a one-year limited warranty. As a verilux customer, your satisfaction means everything to us. We look forward to serving you now and in the future....
Page 3: Save These Instructions
3 save these instructions thank you for purchasing the planet light ® energy saving natural spectrum ® floor lamp. Please read the following safety information before using. To reduce the risk of fire, electrical shock or injury to persons: • do not dismantle. • do not alter power cord. • turn off/u...
Page 4
4 avertissements et précautions • pour usage intérieur seulement. • la lampe est un dispositif électrique. Ne pas utiliser prÈs de l’eau. • avant de brancher la lampe, vérifier que la tension de la prise murale ne dépasse pas 120 volts. • ne pas utiliser avec des gradateurs de lumière, des minuterie...
Page 5: Header
5 header getting started main parts & controls a. Lamp head b. Gooseneck c. Shaft d. Lamp base e. Power cord f. Polarized plug g. Bulb h. High/off/low switch a f c e d b g close-up of lamp head h caution: do not lift the lamp by the gooseneck. The lamp should be lifted by the shaft. Mise en garde : ...
Page 6: Header
6 header 1. Remove all pieces from box. Locate the two phillips head screws. 2. Detach the red plastic protective pieces and store them in the event you need to return the lamp. 3. Important: to avoid scratching the metal shaft, do not use a sharp object to cut the plastic covering. The clear plasti...
Page 7: Header
7 header assembly instructions read instructions carefully before assembly: 1. Connect the two ends of the power cord (between the base and the shaft) using the lock connectors. 2. Carefully tuck excess power cord into the shaft. Do not cut or shorten the power cord. 3. Insert the gooseneck and the ...
Page 8: Header
8 header assembly instructions cont. 5. To prevent damage during shipping, the verilux bulb is surrounded by protective padding. Carefully remove and dispose of the protective padding. Check to ensure that the bulb is fully seated and has not come loose from the socket during shipping. There should ...
Page 9: Header
9 header bulb replacement instructions installation 1. Unplug lamp from power source. 2. Firmly hold the base (b) and push bulb (c) into the socket (a). 3. Be sure the bulb is firmly seated in the socket (see below) and snapped into the metal bulb clip (d). Removal 1. Unplug the lamp from the power ...
Page 10: Header
10 header troubleshooting before requesting service on your verilux ® lamp, please read the following: • make sure all power connectors, cords and plugs are inserted fully and securely. • be sure the bulb is securely seated into the socket (see page 9). • make sure there is power to the wall outlet ...
Page 11: Header
11 header care & cleaning your lamp is made from high quality materials that will last for many years with minimum care. You may want to periodically clean the lamp using a mild non-abrasive cleaner and soft cloth. When cleaning, make sure you have turned off and unplugged the unit, allowing suffici...
Page 12
Pl04-man-rev10 printed in china for verilux, inc. © copyright 2010 verilux, inc. All rights reserved. One year limited warranty attention! Once opened, please do not return this product to the store where it was purchased for repair or replacement! Many questions may be answered by visiting www.Veri...